54 CHAPTER THREE Freshwater (Closed) Cooling Systems Inspection WARNING When performing any service work on the engine or cooling system, never remove the pressure jill cap on the exhaust manifold (Figure 24), drain coolant or disconnect any hose while the engine is hot. Scalding fluid and steam may be blown out under pressure and cause serious injury. Once a year, or whenever troubleshooting the cooling system, check the following items. If the proper equip- ment is not available, have the tests performed by a radia- tor shop. 1. Loosen and remove the pressure fill cap (Figure 24). 2. Check the cap seals for tears or cracks. Check for a bent or distorted cap.
Rinse the cap under warm tap water to flush away any loose rust or dirt particles. 3. Inspect the cap neck seat for dents, distortion or con- tamination. Wipe the sealing surface with a clean cloth to remove any rust or dirt. 4. Check the fluid level and fill the system if necessary as described in the Check/Fill Coolant section in this chap- ter. 5. Check all cooling system hoses for damage or deterio- ration. Replace any hose that is questionable. Make sure all hose clamps are tight. 6. Check the heat exchanger (Figure 25) for cracks or damage. Service, if necessary, as described in Chapter Eight. Check/Fill Coolant (Equipped With a Remote Reservoir) Refer to Figure 26. 1.
Check the level of the coolant in the remote reservoir tank (Figure 26) when the engine is cold. The coolant level should be between the marks on the tank. 2. If the coolant level is low, but the tank is not dry, add coolant to the tank. Refer to the following section for the proper coolant mixture. WARNING Do not remove the pressure jill cap (Figure 24) from the pressurized cooling system when the engine is hot. 3. If the coolant level is low, but the tank is dry, remove the pressure fill cap on the exhaust manifold (Figure 24). Add coolant to the exhaust manifold so it is full, replace the cap, then add coolant to the remote reservoir tank to the proper level. 4.
Run the engine until it reaches normal operating tem- perature, then let the engine cool. Recheck the coolant level in the remote tank and, if necessary, refill the remote reservoir tank. Check/fill coolant (not equipped with remote reservoir) WARNING Do not remove the jill pressure cap (Figure 24) from the pressurized cooling system when the engine is hot. 1. Loosen and remove the pressure fill cap (Figure 24). 2. Check the level of fluid in the system. It should be level with the iron plate at the bottom of the filler neck. Coolant NOTE Excess coolant (above proper level) will be expelled when coolant reaches operating temperature.
Only use a high-quality ethylene glycol-based anti- freeze designed for aluminum engines. Mix the antifreeze with water in a 50/50 ratio. Coolant capacity is listed in Table 4. When mixing antifreeze with water, use only soft or distilled water. Distilled water can be purchased at su- permarkets in gallon containers. Do not use tap or salt wa- ter because it will damage engine parts. 3. Ifthe exhaust manifold is not properly filled, add cool- ant. Refer to the Coolant section in this chapter for proper coolant.