56 CHAPTER THREE flush it down a drain or pour it on the ground. Put it in suitable containers and dispose of it according to local regulations. CAUTION Be careful not to spill antifreeze on painted surfaces, as it may damage the surface. Wash any spilled antifreeze immediately with soapy water, then rinse the area thor- oughly with clean water. Flushing and refillingfreshwater coolant system Use the following procedure to flush and refill the freshwater coolant system. Refer to the preceding section to flush the seawater portion of a freshwater coolant sys- tem. Replace the coolant in the freshwater coolant system af- ter every 500 hours of operation or annually, whichever occurs first.
CAUTION Perform the following procedure when the engine is cold. 1. Remove the pressure fill cap (Figure 24). NOTE Position the drain hoses in suitable contain- ers to catch coolant when draining the cool- ant from the exhaust manifold and engine. ~)y;;:1r~"":""_- Drain plug 2. Open the drain valve at the end of the heat exchanger (A, Figure 27) and the drain plug on the underside of the exhaust manifold (B). 3. Unscrew the drain plug on the side of the engine block (Figure 28, typical). 4. If an excessive accumulation of scale is apparent on the interior ofthe cooling system, use an automotive cool- ing system cleaner.
Be sure to thoroughly flush out the cooling system with freshwater afterward. 5. Close the drain plug on the exhaust manifold and the drain plug on the engine block. 6A. Engines without a remote reservoir-Fill the exhaust manifold with coolant. The coolant should be level with the iron plate at the bottom of the filler neck. 68. Engines with a remote reservoir-Pour coolant into the exhaust manifold so it is full. Install the pressure fill cap, then add coolant to the remote reservoir tank to the proper level. 7. Run the engine until it reaches normal operating tem- perature, then let the engine cool. Recheck the coolant level and, if necessary, add coolant.
BATTERY Inspect the electrical connections and make sure they are secure and corrosion-free. If corrosion is present at the terminal ends, detach the wires, clean the corrosion and reattach. Make sure that wires are correctly routed and will not contact moving parts or touch hot (especially ex- haust) parts. Remove the battery vent caps and check battery electro- lyte level. It should be about 3/16 in. above the plates or even with the bottom of the filler wells. See Figure 29. Test the battery condition with a hydrometer (Figure 30). See Chapter Nine.