66 CHAPTER FOUR able containers and dispose of it according to local regulations. Make sure to wipe up any spills and cover any containers of anti- freeze. Keep antifreeze out of the reach of children and animals. done, determine if the work is easier, and possibly more economical, if performed before returning the engine to service. 1. Remove all covers placed over engine openings during lay-up. 2. If the seawater cooling system is filled with an anti- freeze solution, drain the antifreeze from the system using the draining procedure described for the seawater cooling system or the procedure for the seawater section if equipped with a freshwater (closed) cooling system. 3.
Open the drain on the underside of the exhaust mani- fold (Figure 1). 4. Open the drain on the engine block (Figure 2, typical). 5. Allow the freshwater section to drain completely. 6. On models equipped with a remote reservoir, discon- nect the hose to the engine and drain the coolant from the reservoir. Reconnect the hose. 7. Close the drain plugs. 8. If refilling the freshwater section, refer to Chapter Three for the filling procedure. 3. If left loose during lay-up, tighten the seawater pump cover screws (Figure 3). 4. Adjust belt tension for the water pump and alternator drive belts as described in Chapter Three. 5. Replace all fuel filters. 6.
If equipped with a fuel tank drain valve, open the drain valve and remove any water that may have accumulated in the tank. Seawater cooling section Refer to the following procedure to drain the seawater section. 1. Place a suitable container under the drain, if space per- mits. This will prevent water from draining into the bilge. WARNING Be sure to have a Coast Guard-approved fire extinguisher on hand whenever working aroundfuel. NOTE If no waterflows from the drain, check the drain to make sure it is not obstructed or plugged. NOTE If the fuel in the fuel tank is dirty, old or con- taminated with water, drain or pump out the fuel. Clean the tank and refill with fresh, clean fuel.
Although fuel filters will remove most contaminants, excessively dirty fuel may clog the filters or enter the engine, causing damage. 2. Open the drain on the underside of the exhaust mani- fold end cap (Figure 2). 3. Allow the water to drain completely, then close the drain. 4. Loosen the cover screws on the seawater pump (Fig- ure 3) and drain any water in the pump. If the gasket is damaged, remove the cover and install a new gasket and the cover. 5. Remove the lower end of the cooling system hoses from the pump and exhaust manifold. Lower the hoses and allow them to completely drain. Then reconnect the hoses and clamp securely. 7. Bleed the fuel system as described in Chapter Seven. 8.
Check the battery electrolyte level and fill if necessary. Make certain the battery has a full charge; recharge if nec- essary. Clean the battery terminals and install the battery, making sure the cables are connected properly. Cover the battery terminals with a light coat of petroleum jelly. 9. Check the crankcase oil level. Add oil, if necessary. If the oil was not changed at time of lay-up or if the engine has been in storage for an extended period oftime, change the oil and oil filter. 10. Move the engine control to the STOP position. Posi- tion the decompression lever in the ON position. Engage the starter and crank the engine for 30 seconds.
This pro- cedure will pump engine oil to the engine bearings and other engine parts. 11. On engines equipped with a freshwater cooling sys- tem, check the coolant. If the coolant is contaminated or has reached its scheduled replacement time, drain, flush and refill the freshwater cooling system. NOTE It is possible that undrained water may re- main. Protect the seawater cooling section byfilling it with an antifreeze solution. FITTING OUT Preparing the boat for use after storage is easier if the engine was properly prepared before storage. Refer to the list of needed work that was to be performed before re- turning the engine to service. If there is other work to be