Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

70 CHAPTER FIVE Fuel injector Fuel injector Open :;--1~~!!~~ chamber Precombustion chamber cylinder must not permit compression leakage, which could lower the temperature of the compressed air. Also, the cylinder must not contain fuel that could ignite prema- turely during compression. ENGINE SERIAL NUMBER AND CODE The engine serial number and model designation are lo- cated on a plate attached to the rocker cover (Figure 3). The engine serial number is also stamped on the side of the cylinder block (Figure 4). Near the end of the compression stroke, fuel is injected into the cylinder and ignited by compressed air.

Fuel in- jection continues during several degrees of crankshaft ro- tation, depending upon desired speed and load. Expansion of the air caused by the burning fuel pushes the piston down on the expansion (power) stroke. Have the engine model number and serial number avail- able when ordering parts. Record the engine model and serial numbers and store them for future reference in case the identification plate on the engine is defaced or lost. The exhaust valve opens just before the piston reaches the bottom of travel. The exhaust valve remains open as the piston moves upward pushing burned (exhausted) gas- ses from the cylinder.

REPLACEMENT PARTS Different combustion chamber designs may be used on diesel engines to accomodate specific engine operating criteria. An open combustion chamber (direct injection) design is illustrated in Figure 2. The fuel and air are con- fined to one area. Usually the piston crown is concave to form the combustion chamber and provide turbulence re- quired for mixing the fuel with the compressed air. The shape ofthe combustion chamber and the shape ofthe in- jection spray pattern are matched so that fuel will be dis- tributed evenly throughout the chamber. When installing new parts on the engine, make sure the part is designed for use on a marine engine.

Automotive and marine engine parts may look similar; however, auto- motive parts may not be capable of operating in a harsh marine environment. Use only Yanmar parts or parts approved for use on ma- rine engines. ENGINE REMOVAL PRECAUTIONS The Yanmar engines covered in this manual are equipped with a precombustion chamber for each cylinder (Figure 2). The precombustion chamber increases com- bustion efficiency, which produces greater power with re- duced emmissions. Combustion first occurs in the precombustion chamber when hot, compressed air enters the precombustion chamber just as fuel is injected.

Com- bustion continues as the fuel and air are mixed and forced from the precombustion chamber into the engine cylinder. Additional mixing and ignition are completed in the cylin- der. Some service procedures can be performed with the en- gine in the boat; others require removal. The boat design and service procedure to be performed determines whether the engine must be removed. WARNING The engine is heavy, awkward to handle and has sharp edges. It may shift or drop sud- denly during removal. Toprevent serious in- jury, always observe the following precautions.