Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

S INGLE-CYL INDER ENG INES 71 4. Close the fuel shutoff valve and disconnect the fuel line and the fuel return line. 5. Disconnect the remote contro l cables. 7. Disconnect the electrical wires from the electric starter motor and solenoid that will interfere with engine re- moval. 6. Disconnect the electrical wiring harness connectors. 8. Detach the exhaust system. 9. Detach the driveshaft from the transmission output 5 flange. 10. Remove the eng ine retaining bolts. II . Remove the engi ne and transmiss ion. 12. Remove the transmission from the engine as de- scribed in Chapter Ten. 13. Engine installation is the reverse of removal, plus the follow ing: a.

Tighten the eng ine mounting bolts securely. b. Securely tighten the output flange-to-driveshaft bolts. e. Bleed the fuel system at the fuel filter as described under Fuel Filter in Chapter Three. VALVE CO VER Refer 10 F I ~ uTe 5. To remove the valve cover, proceed as follows: 1. Never place any part of your body wher e a movin g or falling engine may trap. CUI or crush you. 2. If you must push the engine during removal, use a board or similar tool to keep your hands out of danger. 3. Make sure the hoist is designed to lin engines and has enough load capacity for your engine. 4. Make sure the hoist is securely attached to safe lifting points on the engine. 5.

The engine should not be difficult to lift with a proper hoist. If it is. stop lifting. lower the engine back onto its mounts and make sure the engine has been completely separated from the vessel. I. Make sure the decompression lever is in the OFF posi- tion. 2. Unscrew the retaining nut (Figure 6). 3. Remove the valve cover. 5. Clean the gaske t surfaces on the valve cover and cylin- der head. 4. Remove the gasket. 6. Reverse the removal steps to install the valve cover. Be sure 10 in stallthe breather pipe (19, Figure 5). Remcval/ tnstetlarton BREATH ER ASS E ~ I BLY While specific procedures cannot address all engine in- stallations.

r ef er to the following general instructions when removing the engine. A reed-type breather is located in the valve cover. Refer to Chapter Three for a description of breather operation. To service the reed portion of the breather, remove the breather cover (Figure 7). The reed (Figure 8) should lie flat. Replace the reed if it is split, cracked or otherwise damaged . 1. Disconnect the negat ive battery cable. 2. Close the seacock and drain the cooling system as de- scribed in Chapter Four. 3. Disconnect the intake water hose from the seawater cooling pump. Check the oil return hole (Figure 9) inside the breather chamber in the valve cover. If the hole is obstructed.

re- move the valve cover and clean out the hole.