SINGLE-CYLINDER ENGINES 73 CYLINDER HEAD ~ 5 7 2 ~ 5"e 7 ' 6 , 8 ,1 ; &;:: =1 10 j! 11 3 5 1. Nut 2. Washer 3. Rocker shaft stand 4. Pin 5. Nut 6. Bu shing 7. Rocker arm 8. Adjuster 9. Wear cap 10. Keys 11. Valve sp ring retainer 12. Valve spring 13. Valv e seal 14. Valve guide 15. Cy linder head 16. Exhaust valve 17. Intake valve 18. Thermostat housing 19. Boll 20. Washer 21. Gasket 6 ~ 12 @>- - 13 rL -14 ~ ~ - - 1 5 18 19/1 21 ~ II -- 17 16 ~ DEC OMPR ESSION MEC HAl'iISM a. The stra ight end of the spring must sit behind the lug on the valve cover. Position the hooked spring end on top of the lever. b.
The shaft and lever must be properly assembled or the taper pin and tapered holes in the shaft and lever will not align. The cutout portion of the shaft must be down when the lever points toward the pulley end of the engine. The decompression mechanism on the valve cover forces the exhaust valve open to reduce compression pres- sure in the cylinder. Reducing compression pressure en- ables the starter to rotate the crankshaft faster during starting. If the mechanism must be repai red, proceed as follows: 1. Remove the valve cover as previously described. NOTE The lever retaining pin (17. Fi gure 5) is ta- pered. Drive the pin out toward top oflever: CYLINDER HEAD Remova l 2.
Using a suitable punch, drive out the retain ing pin. 3. Remove the shaft assembly from the valve cover. 4. Inspect the mechanism and replace any damaged parts. 5. Reverse the removal procedure to reassemble the de- compression mechanism. Note the following: In some instances, it may be possible to remove the cyl- inder head for service without removing the engine. If en- gine removal is necessary, refer to the previous eng ine removal procedure. R ef er to Figure to for an exp loded view of the cylinder head assembly.