74 CHAP TE R FIV E To rem ove the cylinder head, proceed as follows: 1. Disconnect the negative battery cable. 2. lf not previously performed,drain the cooling system as described in Chapter Four. 3. Remove the alternator as described in Chapter Nine. 4. If not previously disconnected. detach the exhaust hose from the exhaust elbow. 5. Loosen the hose clamps and remove the water hose (A, Figure II ) from the exhaust elbow and thermostat bous- mg. 6. Remove the exhaust elbow. 7. Disconnect the lower water hose ( 8. Figure II ) from the thermostat housing. S. Disconnect the wire lead from the water temperature sender (Figure 12). 9.
Remove the air cleaner and the air cleaner base (Fig- ure 13). 10. Remove the fuel in jec tor and precombustion chamber as described in Chapter Seve n. 11. Remove the valve cover as previously described. 12. Remove the rocker ann stand retaining nut (A, Fil:. UTf.' 14), then remove the rocker assembly (B). 13. Remove the push rods ( F i J:. u n~ 15) and mark them so they can be reinstalled in their original positions. 14. Detach the oil line fitting (FiI:UTe16) from the cylin- der head. 15. Unscrew the cylinder head retaining nuts (Figure 17) in a crossing pattern. 16. Remove the cylinder head and head gasket. Inspection 1.
If service to the valves or rocker ann assembly is re- quired, refer to the Valves and Rocker Shaft Assembly sec- lions.