Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

SINGLE-CYLINDER ENGINES 75 5 Feeler gauge sages with a stiff spiral brush, then blow the particles out with compressed air. NOTE If deposits are found in the intake or exhaust port , remove the valves and clean the por ts. 5. Clean all carbon off the piston top. 6. Cheek the cylinder head studs for damage and replace them if necessary. If a stud is loose, tighten it using the fol- lowing procedure: a. Install two nuts on the stud as shown in Fig ure 18. b. Rotate the nuts so they contact each other, then hold one nut and tighten the other nut against the first nut. c. Tighten the stud in the cylinder block by turning the top nut until reaching a torque of 60 Nom (44 ft.-lb.). d.

Hold the bottom nut, loosen the top nut, and remove both nuts. 7. Check the threaded rocker arm support stud for dam- aged threads. Replace it if necessary. 8. Check for warpage of the cylinder head- to-block gas- ket surface with a straight edg e and feeler gauge (Figure 19). Measure diagonally, as well as end to end. If the gap exceeds 0.07 mm (0.003 in.), have the head resurfaced by a machine shop. 2. Check the cylinder head for signs of oil or water leak- age b ef ore cleaning. Look for corrosion or foreign mate- rial in the oil and water passages. 3. Without removing the valves, remove all depo sits from the combustion chamber.

Use a fine wire brush dipped in solvent or make a scraper from hardwood. Be carefu l not to scratch or gouge the combustion chamber. Inst allation 4. After all carbon is removed from the combustion chamber and ports, clean the entire head in solvent. Look for cracks or other visible signs of damage. Clean the pas- 1. Make sure the cylinder head and block gasket surfac es are clean.