76 CHAPTER FIVE 2. Recheck all oil and water passages for cleanliness. 3. Apply Three Bond 50 gasket scaler to both sides of a new cylinder head gasket. ~ 4. Place the new head gasket over the cylinder head studs on the block. Make sure the TOP mark (Figure 20) on the gasket is up. 5. Carefully lower the head onto the cylinder block. 6. Apply engine oil to the threads on the cylinder head studs . 7. Install and tighten the cylinder head retaining nuts fin- ger-tight. 8. Tighten the nuts following the sequence shown in Fig- ure 21 to a torque of75 Nom (55 ft.-lb.). Tighten the nuts in three equal steps until reach ing the final torgue setting. 9.
Attach the oil line fitting (Figure 16) to the cylinder head. 10. Install the push rods (Figure 15) in their original po- sitions . CYLINDER HEAD TIGHTENING SEQUENCE 11. Install the rocker assembly (13, f ig ur e 14) and the rocker arm stand retaining nut (A). Tighten the nut to 37 Nom (27 ft.-lb.). 12. Install the fuel injector and precombustion chamber as described in Chapter Seven. 13. Install the air cleaner base (Ffgure 13) and the air cleaner. 14. Connect the wire lead to the water temperature sender (Ffgure 12). 15. Connect the lower water hose (B, Figure 11) to the thermostat housing. 16. Install the exhaust elbow. 17. Install the alternator. IS.
If the engine is installed in the boat, proceed as fol- lows: a. Attach the water hose (A, Figure II ) to the exhaust 3. Inspect the rocker arm. The pad on the rocker arm that contacts the valve stem must be smooth. Replace the rocker artu if the pad is damaged or excessively worn . Check the ad ju sting screw push rod seat for galling. Re- place the adjusting screw if it is damaged or excess ively worn. elbow and thermostat housing, then tighten the hose clamps. b. Attach the exhaust hose to the exhaust elbow. e. Connect the negative battery cable to the negative battery term inal. 19. Adjust the valve clearance as described in Chapter Three. 20. Reinstall the valve cover. 4.
Inspect and meas ur e the inside diameter of the rocker arm bushing and the outside diameter of the rocker arm shaft. Replace the rocker arm or rocker arm shaft stand if the measurements exceed the specifications in Table 1. ROCK ER SHAFT ASS EMBLY Each valve is actuated by a rocker arm that rides on a shaft (Figure 22). Each rocker arm is equipped with a bushing in the rocker ann bore. Ribs in the valve cover re- tain the rocker arms on the rocker shafts. NOTE The rocker arm and bushing are available only as a unit assembly. 1. Remove the valve cover as previously described. 2. Remove the rocker arm stand retain ing nut (A, F igure 5.
Reasse mble and reinstall the rocker arm assembly by reversing the removal procedure . Adjust valve clearance as described in Chapter Three. 14), then remove the rocker assembly (B).