SINGLE-CYLINDER ENGINES 77 VALVE COMPONENTS H---l 1"!I---2 ~1G...t--3 ~--4 ~-5 6 1. Wear cap 2. Keys 3. Valve spring retainer 4. Valve spring 5. Valve seal 6. Valve guide 7. Valve !-7 VALVES AND VALVE SEATS Servicing the valves, guides and valve seats must be done by a dealer or machine shop, as special knowledge and expensive machine tools are required. A general practice among those who do their own ser- vice is to remove the cylinder head, perform all disassem- bly except valve removal and take the head to a dealer or machine shop for inspection and service.
Since the cost is low relative to the required effort and equipment, this is usually the best approach, even for experienced mechan- ics. The following procedures are provided to acquaint the home mechanic with the procedure. Valve Removal Refer to Figure 22. 1. Remove the cylinder head as described in this chapter. 2. Remove the rocker shaft assembly as described in this chapter. 3. Remove the wear cap (1, Figure 22) on the valve stem. 4. Compress the valve spring with a compressor like the one shown in Figure 23.