Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

SINGLE-CYLINDER ENGINES 79 Top 8. Check each spring on a flat surface with a steel square. See Figure 27. Slowly revolve the spring 360 0 and note the space between the top of the coil and the square. If it exceeds 1.4 mm (0.055 in.) at any point, replace the spnng. 9. Check the valve guides (Figure 28) for wear and looseness. Refer to Table 1 for valve guide specifications. A loose valve guide must be replaced. Wear cap / Spring retainer Valve Guide Replacement Valve key The cylinder head is equipped with replaceable valve guides (6, Figure 22). The intake and exhaust valve guides are identical. Take the cylinder head to a dealership or machine shop if valve guide replacement is required.

When installing the valve guides, the grooved end must be toward the top of the cylinder head. The groove must be flush with the head surface as shown in Figure 29. ..--......- __ Valve spring Valve guide PUSH RODS 1. Remove the rocker arms as previously described. 2. Remove the push rods and mark them so they can be reinstalled in their original positions. 3. Inspect push rod ends for damage. Maximum allow- able runout is 0.03 mm (0.0012 in.). 4. Reinstall the push rods by reversing removal proce- dure. Adjust valve clearance as described in Chapter Three. PISTON/CONNECTING ROD ASSEMBLY 6. Test the valve springs under load on a spring tester (Figure 26).

Replace any spring that does not meet the specification in Table 1. Piston/Connecting Rod Removal 7. Inspect the valve seats. If worn or burned, they must be reconditioned. This is a job for a dealer or machine shop, although the procedure is described in this chapter. 1. Remove the engine as described in this chapter. 2. Place a suitable container under the oil pan and remove the drain plug. Let the crankcase oil drain, then reinstall the drain plug.