Yanmar — Yanmar Diesel Inboard Shop Manual for One, Two, and Three Cylinder Engines

80 CHAPTER FIVE Feeler gauge ----.("--r---- 1 ----t ).--- , I I I I I I 3. Remove the cylinder head as described in this chapter. NOTE Note the location of the long screw when re- moving the oil pan retaining screws. 4. Remove the oil pan. 5. Rotate the crankshaft until the piston is at bottom dead center. Pack the cylinder bore with clean shop rags. Re- move the carbon ridge at the top ofthe cylinder bore with a ridge reamer. These can be rented for use. Vacuum out the shavings, then remove the shop rags. 6. Rotate the crankshaft until the connecting rod is cen- tered in the bore. Measure the connecting rod side clear- ance with a flat feeler gauge (Figure 30).

If the clearance exceeds specifications (Table 1), replace the connecting rod during reassembly. Piston Pin Removal/Installation The steel piston pin rides directly in the piston and the connecting rod bushing. Circlips at each end retain the piston pin in the piston. 7. Remove the connecting rod bolts. Lift off the cap, along with the lower bearing insert. 1. Before removing the piston, place the crankshaft end of the connecting rod in a vise with soft jaws. Rock the piston as shown in Figure 32. Any rocking motion (do not confuse with the normal sliding motion) indicates wear on the piston pin, piston pin bore or connecting rod small end bore (or a combination of these). 8.

Use a wooden hammer handle to push the piston and connecting rod from the bore. 9. Remove the piston rings with a ring remover (Figure 31).