SINGLE-CYLINDER ENGINES 81 Piston Connecting rod Bearings Rod cap with a hair dryer. Separate the piston from the connecting rod. Bolts Piston/Cylinder Bore Check Unless precision measuring equipment is available, have this procedure done by a machine shop. 1. Measure the piston diameter with a micrometer (Fig- ure 34) at a right angle to the piston pin bore 9 mm (0.35 in.) from the bottom of the piston skirt. 2. Remove the clip from each side of the piston pin bore (Figure 33) with a small screwdriver or scribe. Hold a thumb over one edge of the clip when removing it to pre- vent the clip from springing out. 2.
Measure the cylinder bore diameter at several points with a bore gauge (Figure 35). Figure 36 shows the points of normal cylinder wear. If dimension A exceeds dimension B by more than 0.02 mm (0.0008 in.), rebore the cylinder and install a new piston/ring assembly. 3. Use a wooden dowel or suitable tool and push out the piston pin. If the pin is difficult to remove, heat the piston