SINGLE-CYLI ND ER ENGINES 91 3. Remove the drive disc (Figure 68). 4. Gradually loosen and remove the flywheel bolts, working in a diagonal pattern. Install two drive disc bolts into two outer holes in the flywheel (Figur e 69), then use the screws to pull and remov e the flywheel. 5. Inspect the ring gear. If the ring gear is excessively worn or damaged, usc the following procedure to remove the ring gear: a. Heat the ring gear evenly, then drive the ring gear off the flywhee l. b. Heal the ring gear prior to installation. Drive the ring gear onto the flywheel, being careful not to damage the g ear teeth. 6. Reverse the removal procedure to install the flywheel.
Tighten the flywheel retaining bolts to the torque speci- fied in Table 2. Refer to Chapter Ten to install the drive disc and transm ission. 5 DRIVE DISC Refer to Chapter Ten for drive disc procedures (Figure 68). CRANKSHA FT Rem oval and Installation Refer to Figure 70. 1. Remove the flywheel as previously described. 2. Remove the bellhousing (A, Fig ure 71). 3. Remove the piston and connecting rod as previously described. 4. Remove the oil pump as previously described. 5. Remove the crankshaft gear (Figure 72). 6. Refer to Camshaft to remove the camshaft gear. 7. Remove the thrust washer (Fig ure 73) and thrust bear- ing (Figur e 74).
NOTE Support the crankshaft while removing the main bearing housing in the next step. 8. Remove the main bearing housing (8, Fig ure 71). 9. Remove the crankshaft. 10. Proceed as follows to replace the crankshaft seal in the main bearing housing: a large screwdriver. Work carefully to prevent dam- age to the main bearing housing seal su rf ace. b. Clean the seal recess in the housing with solvent and dry with compressed air. c. Apply gasket sealer to the periphery of the seal. a. Pry the old seal from the main bearing housing with