92 CHAPTER FIVE B Cam shaft gear A d. Position the new seal in the housing recess with its open end facing the inside of the bearing hous ing. Drive the seal into place with a suitably sized seal driver. II. Refer to Main Bearings for info rmation con cern ing inspection of the main bearings and thrust bearings. 12. Reinstall the crankshaft by reversing the removal procedure white noting the followi ng: a. Thoroughly lubricate the main bearings and thrust g. Measure crankshaft end play by inserting a feeler bearings. b. Install the inner, front thrust bearing so the oil grooves arc toward the inside of the crankcase and the tab fils into the recess (Fig ur e 75) in the cran k- case.
Apply a light coating of grease to hold the gauge between the crankshaft main journal and the inner thrust bearing, or by installing a dial gauge that measures fore and aft movement of the fly- wheel or crankshaft. Using a large screwdriver, force the crankshaft back and forth . Measure crank- shaft end play and compare the measurement with the specificat ion in Ta ble 1. Replace the inner thrust bearing to obta in the des ired end play. thrust bearing in place. c. Install a new O-ring (A, Figure 76) on the main bearing housing. d. Tighten the main bearing housing bolts to the torque specified in Table 2. e. Install the outer front thrust bearing so the oi l h.
Align the timing marks (Figure 78) on the cams haft and crankshaft gears when installing the crankshaft gear. grooves (A, Figur e 77) are toward the outside oft he crankcase and the tab (B) fits onto the pin in the crankcase. f. Install the thrust washer (Figure 73) so the beveled side of the inner hole is toward the crankcase. l. Check gear backlash by installing a dial indicator as shown in Figure 79 or by rotating the gear teeth with soft solder between the gear teeth. Compare the measurement with the specification in Table I. -----