Detroit Diesel — Detroit Diesel Series 60 EGR Technician's Guide

SERIES 60 EGR TECHNICIAN'S GUIDE Table 4-1 Flash Codes, SAE Codes, Descriptions LOGIC CODES (MECHANICAL FAILURES) Logic codes indicate the detection of mechanical failures by the DDEC system. The response will be a Flash Code. Diagnosing Flash Code 39 Failure Mode : SID 146, FMI 7 — EGR Valve Not Responding Indicates : EGR flow requested by DDEC and no EGR flow detected. SID 146, FMI 7 will be set by the ECM if, the signal from the Delta P sensor and EGR temperature sensor indicate EGR flow is below a minimum allowable flow when the ECM is in “EGR Mode” for a period greater than 50 seconds. Response :

The CEL will be illuminated and the system will be forced into “Boost Mode” (EGR is Disabled) for the remainder of the ignition cycle. Possible Causes : EGR valve mechanical failure (closed) Plugged EGR cooler Defective Delta P sensor Plugged Delta P ports VNT vanes stuck in an open position Exhaust leaking at the S Pipe Exhaust leaking at the EGR valve Leaking air lines from the VPOD to the actuators (insufficient air supply) Leaking or low vehicle air supply to the VPODs VPOD mechanical failure All information subject to change without notice. (Rev.

April 2004) 4-7 7SE60 0404 Copyright © 2004 DETROIT DIESEL CORPORATION DDC Code # (Flashed) PID SID FMI Description 83 73 - 0 Pump Pressure High 83 411 - 0 EGR Delta Pressure High 83 412 - 0 EGR Temperature High 85 190 - 0 Engine Overspeed 85 190 - 14 Engine Overspeed Signal 86 73 - 3 Pump Pressure Sensor Input Voltage High 86 108 - 3 Barometric Pressure Sensor Input Voltage High 87 73 - 4 Pump Pressure Sensor Input Voltage Low 87 108 - 4 Barometric Pressure Sensor Input Voltage Low