Detroit Diesel — Detroit Diesel Series 60 EGR Technician's Guide

CODES Failure Mode : SID 146, FMI 2 — EGR Leak (Boost Mode) Indicates : No EGR flow requested by DDEC and EGR flow detected. SID 146, FMI 2 will be set by the ECM if, the signal from the Delta P sensor and EGR temperature sensor indicate EGR flow is above a maximum allowable flow when the ECM is in “Boost Mode” for a period greater than 50 seconds. Response : The CEL will illuminate and a fault message will be generated. Possible Causes : EGR valve mechanical failure (open) Defective Delta P sensor Plugged Delta P lines Failure Mode : SID 146, FMI 12 — EGR Leak (Boost Jake) Indicates : No EGR flow requested by DDEC andEGR flow is detected while braking.

SID 146, FMI 12 will be set by the ECM if, the signal from the Delta P sensor and EGR temperature sensor indicate EGR flow is above a maximum allowable flow when the ECM is in “Jake Mode” for a period greater than 50 seconds. Response : The CEL will illuminate and a fault message will be generated. Possible Causes : EGR valve mechanical failure (open) Defective Delta P sensor Plugged Delta P lines 4-8 All information subject to change without notice. (Rev. April 2004) 7SE60 0404 Copyright © 2004 DETROIT DIESEL CORPORATION