SERIES 60 EGR TECHNICIAN'S GUIDE Exhaust Smell/Fumes Perform the following steps for Exhaust Smell/Fumes . 1. Visually inspect the exhaust system for leaks (e.g. exhaust manifold, S-pipe, and turbocharger). [a] If exhaust leaks were detected, repair as necessary. [b] If no exhaust leaks were detected, perform step 2. 2. Tighten all S-pipe clamps to the proper torque specification. 3. Reprogram the ECM. Slobbering Perform the following steps for Slobbering . 1. Visually inspect the entire length of the breather tube for kinks. [a] If the breather tube is damaged, repair as necessary. [b] If the breather tube is not damaged, perform step 2. 2. Perform a DDC Extraction of DDEC Reports. NOTE:
Review extraction for excessive idle time. Times of 35% and higher are considered excessive. 3. Drain the engine lubrication oil pan. 4. Refill the lubrication oil pan with 32 quarts of approved motor oil and visually inspect the oil dipstick marking. [a] If the oil dipstick marking is incorrect, replace the dipstick with a proper dipstick. [b] If the oil dipstick marking was correct, testing is complete. Engine Vibration Perform the following steps for Engine Vibration . 1. Using a 0.060 in. feeler gage, measure the clearance between the bottom of the steel engine mount and the rubber biscuit at the rear engine chassis mounts.
[a] If the engine mount clearance is less than 0.060 in., replace the mount. [b] If the engine mount clearance is greater than 0.060 in., testing is complete. All information subject to change without notice. (Rev. April 2004) 5-5 7SE60 0404 Copyright © 2004 DETROIT DIESEL CORPORATION