DDEC IV TESTING Engine Coolant Loss Perform the following steps for Engine Coolant Loss . 1. Verify the quantity of engine coolant loss per mile. NOTE: _______________Miles driven_______________Coolant added PRESSURIZED AIR AND FLYING PARTICLES To avoid injury to eye or face, wear a face shield or goggles when conducting a pressure test. 2. Pressure test the cooling system. 3. Visually inspect the engine for external coolant leaks (e.g. water pump, coolant hoses, etc.). [a] If coolant leaks were detected, replace the leaking component as required. [b] If no coolant leaks were detected, perform step 4. 4. Visually inspect the engine oil for coolant.
[a] Coolant is found in the engine oil, this indicates an oil cooler or internal engine fault. [b] If no coolant is found, perform step 4[c]. [c] If the engine is losing coolant at a rate of more than 1 gallon in in 5000 miles, and no engine coolant leaks were detected, replace the EGR cooler. [d] If the engine is losing coolant at a rate of less than 1 gallon in 5000 miles, contact the Detroit Diesel Technical Service Group. Engine Backfire, Engine Misfire, Intermittent Exhaust Smoke Perform the following steps for Engine Backfire, Engine Misfire, and Intermittent Exhaust Smoke . 1. Reprogram the ECM. 5-6 All information subject to change without notice. (Rev.
April 2004) 7SE60 0404 Copyright © 2004 DETROIT DIESEL CORPORATION