Detroit Diesel — Detroit Diesel Series 60 EGR Technician's Guide

SERIES 60 EGR TECHNICIAN'S GUIDE Check for Active Codes Check for active codes as follows: 1. Turn ignition ON. 2. Plug in DDR/DDDL. 3. Read active codes. 4. Record or print codes. Ensure that PID, SID, and FMI are recorded. Refer to the proper code section of the DDEC III/IV Single ECM Troubleshooting Guide , (6SE497) to troubleshoot that code. NOTE: FMIs listed as 14 are diagnostic information codes and no troubleshooting is required. For example, an engine derates due to high TCO temperature; a 404/14 code will be stored. This would indicate that conditions warranted having the ECM derate the fueling to the engine.

If the customer complaint was a power loss, it could be explained that loss of power was done by the ECM to protect other engine components. 5. If the issue is not related to the EGR system components, or assistance is needed, contact Detroit Diesel Technical Service. Test Follow these steps to test: 1. Reassemble connectors or components. 2. Start and run the engine. 3. Perform a road test if this is necessary to duplicate original complaint. [a] If symptoms/codes are gone, repairs are complete. [b] If any codes display, review this section again; contact Detroit Diesel Technical Service. All information subject to change without notice. (Rev.

April 2004) 5-13 7SE60 0404 Copyright © 2004 DETROIT DIESEL CORPORATION