Detroit Diesel — Detroit Diesel Series 60 EGR Technician's Guide

DDEC IV TESTING Check VPOD Wiring The following checks should be performed for the VPOD wiring. NOTE: VPOD power should have been verified under the P/N check. If not, refer to Check Variable Output Pressure Device (VPOD) P/N and Supply Voltage. . 1. Turn ignition switch ON. 2. Unplug the VPOD mating connector. 3. Insert a 1,000 ohm resistor between cavities #2 and #1 for the 12V version, or cavities #2 and #3 for the 24V version. 4. Connect a VOM to the VPOD connector between pin #2 and pin #3 for the 12V VPOD or pin #2 and pin #1 for the 24V VPOD. 5. Using a DDR/DDDL, activate the PWM #2 (EGR Valve) and PWM #4 (VNT), and ensure: [a] Activating 11 % duty cycle:

VDC = 90% of the VPOD supply voltage ± 1 volt (e.g. voltage to VPOD = 13.8V * 0.9 = 12.42V; therefore 11.42V to 13.42V at PWM is okay.) [b] Activating 90 % duty cycle: VDC = 10% of the VPOD supply voltage ± 1 volt. (e.g. voltage to VPOD = 13.8V * 0.1 = 1.38V, therefore 0.38V to 2.38V at PWM is okay. 6. Note any air leakage when PWMs are activated to 90% and correct the leaks as needed. [a] If both of the PWM voltage measurements are correct, replace the VPOD that had the wrong pressure reading. [b] If the PWM voltage measurements are incorrect, and the wiring checks are okay, try a test ECM programmed for EGR, or contact DDC Technical Service.

5-12 All information subject to change without notice. (Rev. April 2004) 7SE60 0404 Copyright © 2004 DETROIT DIESEL CORPORATION