fi ci- Illustration 4 2 3 1 Illustration Maintenance work: Engine oil system 50 operating hours after t he initial operation and subsequently, at intervals of 500 operating hours 3 2 1. Oil change at the Diesel engine i NOTE! Take the tandem roller to a workshop in order to carry out the oil change. WARNING! Environmental protection! Engine oil must not penetrate the ground, pollute water or leak into the sewer system. Collect it in suffici- ently dimensioned receptacles and dispose of it in accordance with the EU waste disposal key: 130202. • Start the Diesel engine and let it run until it has reached operating temperature. • Stop the Diesel engine and remove the ignition key. WARNING!
Risk of burns! The leaking oil, the engine and its environment are extremely hot. Be sure to wear protective clothing! • Unscrew the oil drain plug (3), pull out the oil dipstick (1) and drain the hydraulic oil. • Screw in the oil drain plug (3), fitted with a new O-ring. 2. Replacing the oil filter • Place an oilpan under the oil filter ( 4) to collect the leaking oil. • Unscrew the filter housing (cartridge) and dispose of it in accordance with EU waste disposal key 150299. 4 • Lubricate the surface of the new cartridge. Attach the cartridge and screw it on manually. 3. Adding oil i NOTE! For information on the required specifications of the engine oil, refer to the table of lubricants.
1 • Fill a sufficient amount of new engine oil into the Diesel engine via the filler neck (2). • After adding oil, attach the closing cap and start the Diesel engine. • Check the oil level at the oil dipstick (1). Add oil, if necessary. • Start the Diesel engine and let it idle until it has warmed up.