fi ci- Illustration ciently 3 1 Illustration Maintenance work: Replacing the hydraulic oil and the oil filter cartridges at intervals of 2000 operating hours (i.e. you need to change the type of oil) 1 3 i NOTE! Take the tandem roller to a workshop in order to carry out the oil change. WARNING! Environmental protection! Engine oil must not penetrate the ground, pollute water or leak into the sewer system. Collect it in suffici- ently dimensioned receptacles and dispose of it in accordance with the EU waste disposal key: 130202. • Start the Diesel engine and let it run until the hydraulic oil has warmed up. • Stop the Diesel engine and remove the ignition key.
• Place an oilpan under the hydraulic tank. • Unscrew the ventilation filter. NOTE! i Be sure to take the amount of hydraulic oil to be drained into account and to use a sufficiently dimensioned oilpan to collect the leaking oil. • Unscrew the oil drain plug. • Dispose of the waste oil in an environmentally friendly way (EU waste disposal key 130202). • Replace the oil filter cartridge ( 3), see instructions above. • Screw in the oil drain plug, fitted with a new O-ring. • Add hydraulic oil via the oil filter. CAUTION! Be sure to exercise extreme cleanliness when fi lling in hydraulic oil! Inform yourself of the type of hydraulic oil in the hydraulic system.
Please refer to the table of lubricants for the required specifications. • Fill in hydraulic oil via the oil filter. • Start the Diesel engine and let it run until the hydraulic oil has warmed up. • Stop the Diesel engine and pull out the ignition key. • Check the hydraulic oil level at the inspection glass (1).