A . C . Make sure the MA or MB . The 0-position switch ( defective. The tandem roller does not start. The Diesel engine does not start. The tandem roller does not move in the desired direction of motion. The tandem roller speed is too low. Failure / Problem Failure / Problem 7.1.5 Problems and trouble-shooting Failure / Problem Causes and actions to be taken The Diesel engine does not start. • The parking brake has not been applied. Activate the parking brake. • The joystick is not in the neutral position. Move the joystick into the neutral position. Move the frequency lever to position A.
• The 0-position switch (S02) on the travel pump is Conduct an electrical measurement of the 0-position defective. switch or replace it. The tandem roller does not move in the desired direction of motion. • No or insuf cient control oil pressure. The control oil pump is defective. Establish the control oil pressure at measuring point PS. • The Bowden cable is defective. The transmission between the joystick and the travel pump adjustment is not correctly set or torn. The tandem roller does not start. • The parking brake has not been deactivated, Deactivate the parking brake and actuate the joystick. which is indicated by a warning sound.
• An electrical fault has occured while deactivating the parking brake, see chapter Electrical system. The tandem roller speed is too low. • The Diesel engine speed is too low. Set the frequency lever to position C. Make sure the Diesel engine speed is increased. • Insuf cient drive pressure. Establish the drive pressure (forward/reverse travel) at one of the measuring points MA or MB.