Make the required settings at the Bowden cable ( 4 ) of the Diesel engine by adjusting the shroud ( 1 ) of the Bowden cable ( 4 ). Deactivate the vibration by actuating the vibration on/off button on the joystick. Stop and secure the Diesel engine. Loosen the counter nut ( 3 ) at the shroud of the Bowden cable ( 1 ). Adjust the shroud ( 1 ) by turning the adjusting nut ( 2 ) to establish the correct vibration frequency. Increase the vibration frequency by turning the adjusting nut ( 2 ) clockwise. Reduce the vibration frequency by turning the adjusting nut counterclockwise ( 2 ) . After completing the required adjustments,tighten the counter nut ( 3 ) again. Vibration system 8 - 8 Issue:
01-10 NOTE! Make sure that the hydraulic oil temperature has reached a temperature of approx. 50є C before checking and adjusting the vibration frequency. i NOTE! After each adjustment at the Bowden cable shroud ( 1 ), check the vibration frequency again, see Checking the low vibration frequency . i Setting the vibration frequency 8.2.3 Setting the low vibration frequency 3 2 1 4