Caterpillar — Caterpillar C11 and C13 Industrial Engines Operation and Maintenance Manual

SEBU7901-01 55 Maintenance Section Battery or Battery Cable - Disconnect i01492654 Battery or Battery Cable - Disconnect If the belts are too tight, unnecessary stress is placed on the components. This reduces the service life of the components. Replacement SMCS Code: 1402-029 For applications that require multiple drive belts, replace the drive belts in matched sets. Replacing one drive belt of a matched set will cause the new drive belt to carry more load because the older drive belts are stretched. The additional load on the new drive belt could cause the new drive belt to fail. The battery cables or the batteries should not be removed with the battery cover in place.

The bat- tery cover should be removed before any servic- ing is attempted. Alternator Belt Adjustment Removing the battery cables or the batteries with the cover in place may cause a battery explosion resulting in personal injury. 1. Turn the start switch to the OFF position. Turn the ignition switch (if equipped) to the OFF position and remove the key and all electrical loads. 2. Disconnect the negative battery terminal at the battery that goes to the start switch. Ensure that the cable cannot contact the terminal. When four 12 volt batteries are involved, the negative side of two batteries must be disconnected. 3. Tape the leads in order to help prevent accidental starting.

g00788814 Illustration 25 1. Remove the belt guard. 4. Proceed with necessary system repairs. Reverse the steps in order to reconnect all of the cables. 2. Loosen mounting bolts (1) and adjusting bolt (2). i02042962 Belts - Inspect/Adjust/Replace 3. Move the assembly in order to increase or decrease the belt tension. 4. Tighten adjusting bolt (2). Tighten mounting bolts (1). SMCS Code: 1357-025; 1357-040; 1357-510 Inspection 5. Reinstall the belt guard. Inspect the alternator belt and the fan drive belts for wear and for cracking. Replace the belts if the belts are not in good condition.

If new drive belts are installed, check the drive belt tension again after 30 minutes of engine operation at the rated rpm. Check the belt tension according to the information in the Service Manual, “Specifications”. Adjustment of the Fan Drive Belt Slippage of loose belts can reduce the efficiency of the driven components. Vibration of loose belts can cause unnecessary wear on the following components: 1. Remove the belt guard. 2. Loosen the mounting bolt for the pulley. 3. Loosen the adjusting nut for the pulley. Belts 4. Move the pulley in order to adjust the belt tension. Pulleys 5. Tighten the adjusting nut. Bearings 6. Tighten the mounting bolt.