SEBU7901-01 65 Maintenance Section Electronic Unit Injector - Inspect/Adjust Inspect the Drive Coupling The operation of Caterpillar engines with improper adjustments of the electronic unit injector can reduce engine efficiency. This reduced efficiency could result in excessive fuel usage and/or shortened engine component life. Inspect the drive coupling according to the instructions that are provided by the OEM of the coupling. For the following service information, see the literature that is provided by the OEM of the coupling: Only qualified service personnel should perform this maintenance. Refer to the following topics for your engine for the correct procedure:
Refer to the Systems Operation, Testing and Adjusting, “Electronic Unit Injector - Test” for the test procedure, and Systems Operation, Testing and Adjusting, “Electronic Unit Injector - Adjust” for the correct procedure for adjusting the injectors. Lubrication requirements Specifications for the end play “Reusability Guidelines” Replacement instructions NOTICE The camshafts must be correctly timed with the crank- shaft before an adjustment of the lash for the fuel in- jector is made. The timing pins must be removed from the camshafts before the crankshaft is turned or dam- age to the cylinder block will be the result. Inspect the Rear Gear Train Inspect the crankshaft gear.
If excessive wear is found, replace the crankshaft gear and the large cluster idler. If any gear causes damage to other gears through failure, replace the entire rear gear train. i02052170 Electronics Grounding Stud - Inspect/Clean/Tighten For the correct parts, see the Parts Manual for the engine. For removal and replacement instructions, see the Service Manual, “Disassembly and Assembly” module. Consult your Caterpillar dealer for assistance. SMCS Code:
7423-040; 7423-070; 7423-079 i02070777 Electronic Unit Injector - Inspect/Adjust The connection of battery cables to a battery and the disconnection of battery cables from a battery may cause an explosion which may result in injury or death. The connection and the disconnection of other electrical equipment may also cause an explosion which may result in injury or death. The procedures for the connection and the disconnec- tion of battery cables and other electrical equip- ment should only be performed in a nonexplosive atmosphere. SMCS Code: 1251-025; 1251-040; 1290-025; 1290-040 Be sure the engine cannot be started while this maintenance is being performed.
To prevent pos- sible injury, do not use the starting motor to turn the flywheel. Hot engine components can cause burns. Allow additional time for the engine to cool before mea- suring/adjusting the unit injectors. The electronic unit injectors use high voltage. Dis- connect the unit injector enable circuit connector in order to prevent personal injury. Do not come in contact with the injector terminals while the en- gine is running.