Caterpillar — Caterpillar C11 and C13 Industrial Engines Operation and Maintenance Manual

64 SEBU7901-01 Maintenance Section Crankshaft Vibration Damper - Inspect A water temperature regulator that fails in the open position will cause the engine operating temperature to be too low during partial load operation. Low engine operating temperatures during partial loads could cause an excessive carbon buildup inside the cylinders. This excessive carbon buildup could result in an accelerated wear of the piston rings and wear of the cylinder liner. Inspect the damper for evidence of fluid leaks. If a fluid leak is found, determine the type of fluid. The fluid in the damper is silicone. Silicone has the following characteristics:

transparent, viscous, smooth, and difficult to remove from surfaces. If the fluid leak is oil, inspect the crankshaft seals for leaks. If a leak is observed, replace the crankshaft seals. NOTICE Failure to replace your water temperature regulator on a regularly scheduled basis could cause severe engine damage. Inspect the damper and repair or replace the damper for any of the following reasons: The damper is dented, cracked, or leaking. Caterpillar engines incorporate a shunt design cooling system and require operating the engine with a water temperature regulator installed. The paint on the damper is discolored from heat. The engine has had a failure because of a broken crankshaft.

If the water temperature regulator is installed incor- rectly, the engine may overheat, causing cylinder head damage. Ensure that the new water temperature reg- ulator is installed in the original position. Ensure that the water temperature regulator vent hole is open. Analysis of the oil has revealed that the front main bearing is badly worn. There is a large amount of gear train wear that is not caused by a lack of oil. Do not use liquid gasket material on the gasket or cylinder head surface. Refer to the Service Manual or consult your Caterpillar dealer for information about damper replacement.

Refer to the Service Manual for the replacement procedure of the water temperature regulator, or consult your Caterpillar dealer. Note: If only the water temperature regulators are replaced, drain the coolant from the cooling system to a level that is below the water temperature regulator housing. i00934883 Driven Equipment - Check SMCS Code: 3279-535 Check the Alignment i00934535 Crankshaft Vibration Damper - Inspect To minimize bearing problems and vibration of the engine crankshaft and the driven equipment, the alignment between the engine and driven equipment must be properly maintained. SMCS Code:

1205-040 Check the alignment according to the instructions that are provided by the following manufacturers: Damage to the crankshaft vibration damper or failure of the crankshaft vibration damper can increase torsional vibrations. This can result in damage to the crankshaft and to other engine components. A damper that is damaged can cause excessive gear train noise at variable points in the speed range. Caterpillar OEM of the drive coupling The damper is mounted to the crankshaft which is located behind the belt guard on the front of the engine. OEM of the driven equipment Torque all of the fasteners to the proper specifications.

Visconic Damper The visconic damper has a weight that is located inside a fluid filled case. The weight moves in the case in order to limit torsional vibration.