SEBU7901-01 63 Maintenance Section Cooling System Water Temperature Regulator - Replace 3. Add tap water to the mixing bottle in order to bring the level up to the “10 ml” mark. Place the cap on the bottle and shake the bottle. NOTICE Excessive supplemental coolant additive concentra- tion can form deposits on the higher temperature sur- faces of the cooling system, reducing the engine’s heat transfer characteristics. Reduced heat transfer could cause cracking of the cylinder head and other high temperature components. 4. Add 2 to 3 drops of the “NITRITE INDICATOR SOLUTION B” to the mixing bottle. Move the bottle in a circular motion in order to mix the solution. 5.
Add 1 drop of “NITRITE TEST SOLUTION A” to the mixing bottle. Move the bottle in a circular motion in order to mix the solution. Excessive supplemental coolant additive concentra- tion could also result in blockage of the heat exchang- er, overheating, and/or accelerated wear of the water pump seal. 6. Repeat 5 until the solution changes color from red to light gray, green, or blue. Record the number of drops of “NITRITE TEST SOLUTION A” that were required to cause the color change. Do not exceed the recommended amount of supple- mental coolant additive concentration. 7. Use Table 13 to interpret the results. Table 13 3. Add the proper amount of SCA.
For the proper amount of SCA, refer to this Operation and Maintenance Manual, “Refill Capacities and Recommendations” topic. The proper concentration of SCA depends on the type of coolant that is used. For the proper concentration of SCA, refer to Special Publication, SEBU6251, “Caterpillar Commercial Diesel Engine Fluids Recommendations”. 4. Clean the cooling system filler cap. Install the cooling system filler cap. i00912898 Cooling System Water Temperature Regulator - Replace Add the SCA, If Necessary SMCS Code: 1355-510 Replace the water temperature regulator before the water temperature regulator fails. This is a recommended preventive maintenance practice.
Replacing the water temperature regulator reduces the chances for unscheduled downtime. Pressurized System: Hot coolant can cause seri- ous burns. To open the cooling system filler cap, stop the engine and wait until the cooling system components are cool. Loosen the cooling system pressure cap slowly in order to relieve the pres- sure. A water temperature regulator that fails in a partially opened position can cause overheating or overcooling of the engine. A water temperature regulator that fails in the closed position can cause excessive overheating. Excessive overheating could result in cracking of the cylinder head or piston seizure problems. 1.
Remove the cooling system filler cap slowly. Note: Always dispose of fluids according to local regulations. 2. If necessary, drain some coolant in order to allow space for the addition of the SCA. Number of Drops Concentration of SCA Maintenance Required Less than 25 Less than the recommended concentration of SCA Add SCA. Retest the coolant. 25 to 30 The recommended concentration of SCA None More than 30 More than the recommended concentration of SCA Remove the coolant. Replace with water only Retest the coolant.