Caterpillar — Caterpillar C11 and C13 Industrial Engines Operation and Maintenance Manual

62 SEBU7901-01 Maintenance Section Cooling System Coolant Sample (Level 2) - Obtain Obtain the sample of the coolant as close as possible to the recommended sampling interval. In order to receive the full effect of S·O·S analysis, you must establish a consistent trend of data. In order to establish a pertinent history of data, perform consistent samplings that are evenly spaced. Supplies for collecting samples can be obtained from your Caterpillar dealer. Submit the sample for Level 2 analysis. For additional information about coolant analysis, see Special Publication, SEBU6251, “Caterpillar Commercial Diesel Engines Fluids Recommendations” or consult your Caterpillar dealer.

i02417522 Cooling System Supplemental Coolant Additive (SCA) - Test/Add Use the following guidelines for proper sampling of the coolant: Complete the information on the label for the sampling bottle before you begin to take the samples. SMCS Code: 1352-045; 1395-081 Keep the unused sampling bottles stored in plastic bags. This maintenance procedure is required for conventional coolants such as DEAC and for mixtures of water and SCA. This maintenance is NOT required for cooling systems that are filled with Extended Life Coolant. Obtain coolant samples directly from the coolant sample port. You should not obtain the samples from any other location.

Keep the lids on empty sampling bottles until you are ready to collect the sample. Place the sample in the mailing tube immediately after obtaining the sample in order to avoid contamination. Cooling system coolant additive contains alkali. To help prevent personal injury, avoid contact with the skin and eyes. Do not drink cooling system coolant additive. Never collect samples from expansion bottles. Never collect samples from the drain for a system. Note: Caterpillar recommends an S·O·S coolant analysis (Level 1). Test the Concentration of the SCA Submit the sample for Level 1 analysis.

For additional information about coolant analysis, see Special Publication, SEBU6251, “Caterpillar Commercial Diesel Engine Fluids Recommendations” or consult your Caterpillar dealer. Coolant/Antifreeze and SCA NOTICE Do not exceed the recommended six percent supple- mental coolant additive concentration. i01987714 Cooling System Coolant Sample (Level 2) - Obtain Test the concentration of the SCA with the 8T-5296 Coolant Conditioner Test Kit. Water and SCA SMCS Code: 1350-008; 1395-008; 1395-554; 7542 NOTICE Do not exceed the recommended eight percent sup- plemental coolant additive concentration.

NOTICE Always use a designated pump for oil sampling, and use a separate designated pump for coolant sampling. Using the same pump for both types of samples may contaminate the samples that are being drawn. This contaminate may cause a false analysis and an incor- rect interpretation that could lead to concerns by both dealers and customers. Test the concentration of the SCA with the 8T-5296 Coolant Conditioner Test Kit. Use the instructions that follow: 1. Fill the syringe to the “1.0 mark with the coolant. Refer to Operation and Maintenance Manual, “Cooling System Coolant Sample (Level 1) - Obtain” for the guidelines for proper sampling of the coolant. 2.

Dispense the 1.0 mL coolant sample from the syringe into the empty mixing bottle.