SEBU7901-01 61 Maintenance Section Cooling System Coolant Level - Check i01197583 Cooling System Coolant Level - Check 3. Clean the cooling system filler cap and check the condition of the filler cap gaskets. Replace the cooling system filler cap if the filler cap gaskets are damaged. Reinstall the cooling system filler cap. SMCS Code: 1395-082 4. Inspect the cooling system for leaks. Check the coolant level when the engine is stopped and cool. i02326688 Cooling System Coolant Sample (Level 1) - Obtain SMCS Code: 1350-008; 1395-008; 1395-554; 7542 Note: Obtaining a Coolant Sample (Level 1) is optional if the cooling system is filled with Cat ELC (Extended Life Coolant).
Cooling systems that are filled with Cat ELC should have a Coolant Sample (Level 2) that is obtained at the recommended interval that is stated in the Maintenance Interval Schedule. Note: Obtain a Coolant Sample (Level 1) if the cooling system is filled with any other coolant instead of Cat ELC. This includes the following types of coolants. g00285520 Illustration 26 Cooling system filler cap Table 12 Pressurized System: Hot coolant can cause seri- ous burns. To open the cooling system filler cap, stop the engine and wait until the cooling system components are cool. Loosen the cooling system pressure cap slowly in order to relieve the pres- sure.
(1) This is the recommended interval for coolant samples for all conventional heavy-duty coolant/antifreeze. This is also the recommended interval for coolant samples of commercial coolants that meet the Cat EC-1 specification for engine coolant. (2) The Level 2 Coolant Analysis should be performed sooner if a problem is suspected or identified. 1. Remove the cooling system filler cap slowly in order to relieve pressure. 2. Maintain the coolant level within 13 mm (0.5 inch) of the bottom of the filler pipe. If the engine is equipped with a sight glass, maintain the coolant level to the proper level in the sight glass.
Commercial long life coolants that meet the Caterpillar Engine Coolant Specification -1 (Caterpillar EC-1) Cat DEAC (Diesel Engine Antifreeze/Coolant) Commercial heavy-duty coolant/antifreeze NOTICE Always use a designated pump for oil sampling, and use a separate designated pump for coolant sampling. Using the same pump for both types of samples may contaminate the samples that are being drawn. This contaminate may cause a false analysis and an incor- rect interpretation that could lead to concerns by both dealers and customers. g00103639 Illustration 27 Typical filler cap gaskets Note: Level 1 results may indicate a need for Level 2 Analysis.
Recommended Interval Type of Coolant Level 1 Level 2 Cat DEAC Every 250 Hours(1) Yearly(1)(2) Cat ELC Optional(2) Yearly(2)