Caterpillar — Caterpillar C11 and C13 Industrial Engines Operation and Maintenance Manual

60 SEBU7901-01 Maintenance Section Cooling System Coolant Extender (ELC) - Add 2. Start the engine and operate the engine at low idle. Increase the engine rpm to high idle. Operate the engine at high idle for one minute in order to purge air from the cavities of the engine block. Stop the engine. Personal injury can result from hot coolant, steam and alkali. 3. Check the coolant level. Maintain the coolant level within 13 mm (.5 inch) below the bottom of the pipe for filling. Maintain the coolant level within 13 mm (.5 inch) to the proper level on the sight glass (if equipped). At operating temperature, engine coolant is hot and under pressure.

The radiator and all lines to heaters or the engine contain hot coolant or steam. Any contact can cause severe burns. 4. Clean the cooling system filler cap. Inspect the gasket that is on the cooling system filler cap. If the gasket that is on the cooling system filler cap is damaged, discard the old cooling system filler cap and install a new cooling system filler cap. If the gasket that is on the cooling system filler cap is not damaged, use a 9S-8140 Pressurizing Pump in order to pressure test the cooling system filler cap. The correct pressure for the cooling system filler cap is stamped on the face of the cooling system filler cap.

If the cooling system filler cap does not retain the correct pressure, install a new cooling system filler cap. Remove cooling system pressure cap slowly to relieve pressure only when engine is stopped and cooling system pressure cap is cool enough to touch with your bare hand. Do not attempt to tighten hose connections when the coolant is hot, the hose can come off causing burns. Cooling System Coolant Additive contains alkali. Avoid contact with skin and eyes. NOTICE Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, test- ing, adjusting and repair of the product.

Be prepared to collect the fluid with suitable containers before open- ing any compartment or disassembling any compo- nent containing fluids. 5. Start the engine. Inspect the cooling system for leaks and for proper operating temperature. i02482066 Cooling System Coolant Extender (ELC) - Add Refer to Special Publication, NENG2500, “Caterpillar Dealer Service Tool Catalog” for tools and supplies suitable to collect and contain fluids on Caterpillar products. SMCS Code: 1352-045; 1395-081 Cat ELC (Extended Life Coolant) does not require the frequent additions of any supplemental cooling additives which are associated with the present conventional coolants.

The Cat ELC Extender only needs to be added once. Dispose of all fluids according to local regulations and mandates. 1. Loosen the cooling system filler cap slowly in order to relieve pressure. Remove the cooling system filler cap. NOTICE Use only Cat Extended Life Coolant (ELC) Extender with Cat ELC. 2. It may be necessary to drain enough coolant from the cooling system in order to add the Cat ELC Extender. Do NOT use conventional supplemental coolant addi- tive (SCA) with Cat ELC. Mixing Cat ELC with conven- tional coolants and/or conventional SCA reduces the Cat ELC service life. 3. Add Cat ELC Extender according to the requirements for your engine’s cooling system capacity.

Refer to the Operation and Maintenance Manual, “Refill Capacities and Recommendations” article for more information. Check the cooling system only when the engine is stopped and cool. 4. Clean the cooling system filler cap. Inspect the gaskets on the cooling system filler cap. Replace the cooling system filler cap if the gaskets are damaged. Install the cooling system filler cap.