68 SEBU7901-01 Maintenance Section Engine Air Cleaner Element (Dual Element) - Clean/Replace Cleaning the Primary Air Cleaner Elements Pressurized Air Pressurized air can be used to clean primary air cleaner elements that have not been cleaned more than two times. Pressurized air will not remove deposits of carbon and oil. Use filtered, dry air with a maximum pressure of 207 kPa (30 psi). NOTICE Caterpillar recommends certified air filter cleaning ser- vices that are available at Caterpillar dealers. The Caterpillar cleaning process uses proven procedures to assure consistent quality and sufficient filter life. Observe the following guidelines if you attempt to clean the filter element:
Do not tap or strike the filter element in order to re- move dust. Do not wash the filter element. Use low pressure compressed air in order to remove the dust from the filter element. Air pressure must not exceed 207 kPa (30 psi). Direct the air flow up the pleats and down the pleats from the inside of the filter element. Take extreme care in order to avoid damage to the pleats. g00281692 Illustration 30 Do not use air filters with damaged pleats, gaskets, or seals. Dirt entering the engine will cause damage to engine components. Note: When the primary air cleaner elements are cleaned, always begin with the clean side (inside) in order to force dirt particles toward the dirty side (outside).
The primary air cleaner element can be used up to six times if the element is properly cleaned and inspected. When the primary air cleaner element is cleaned, check for rips or tears in the filter material. The primary air cleaner element should be replaced at least one time per year. This replacement should be performed regardless of the number of cleanings. Aim the hose so that the air flows inside the element along the length of the filter in order to help prevent damage to the paper pleats. Do not aim the stream of air directly at the primary air cleaner element. Dirt could be forced further into the pleats. Note: Refer to “Inspecting the Primary Air Cleaner Elements”.
Use clean primary air cleaner elements while dirty elements are being cleaned. Vacuum Cleaning NOTICE Do not clean the air cleaner elements by bumping or tapping. This could damage the seals. Do not use el- ements with damaged pleats, gaskets or seals. Dam- aged elements will allow dirt to pass through. Engine damage could result. Vacuum cleaning is a good method for cleaning primary air cleaner elements which require daily cleaning because of a dry, dusty environment. Cleaning with pressurized air is recommended prior to vacuum cleaning. Vacuum cleaning will not remove deposits of carbon and oil. Visually inspect the primary air cleaner elements before cleaning.
Inspect the air cleaner elements for damage to the seal, the gaskets, and the outer cover. Discard any damaged air cleaner elements. Note: Refer to “Inspecting the Primary Air Cleaner Elements”. There are two common methods that are used to clean primary air cleaner elements: Pressurized air Vacuum cleaning