Caterpillar — Caterpillar C11 and C13 Industrial Engines Operation and Maintenance Manual

SEBU7901-01 71 Maintenance Section Engine Mounts - Inspect i02139969 Engine Mounts - Inspect SMCS Code: 1152-040 Inspect the engine mounts for deterioration and for proper bolt torque. Engine vibration can be caused by the following conditions: g00110310 Illustration 36 Improper mounting of the engine (Y) mark (X) mark Deterioration of the engine mounts Any engine mount that shows deterioration should be replaced. Refer to the Specifications Manual, SENR3130, “Torque Specifications”. Refer to your Caterpillar dealer for more information. NOTICE Perform this maintenance with the engine stopped. 1. Maintain the oil level between “ADD” mark (Y) and “FULL” mark (X) on oil level gauge (1).

Do not fill the crankcase above “FULL” mark (X). i02073191 Engine Oil Level - Check NOTICE Engine damage can occur if the crankcase is filled above the mark on the oil level gauge (dip- stick). SMCS Code: 1348-535-FLV An overfull crankcase can enable the crankshaft to dip into the oil. This will reduce the power that is de- veloped and also force air bubbles into the oil. These bubbles (foam) can cause the following problems: re- duction of the oil’s ability to lubricate, reduction of oil pressure, inadequate cooling of the pistons, oil blow- ing out of the crankcase breathers, and excessive oil consumption. Hot oil and hot components can cause personal injury.

Do not allow hot oil or hot components to contact the skin. Excessive oil consumption will enable deposits to form on the pistons and in the combustion chamber. De- posits in the combustion chamber lead to the following problems: guttering of the valves, packing of carbon under the piston rings, and wear of the cylinder liner. If the oil level is above the “FULL” mark on the oil level gauge, drain some of the oil immediately. 2. Remove oil filler cap (2) and add oil, if necessary. For the correct oil to use, see this Operation and Maintenance Manual, “Refill Capacities and Recommendations” topic (Maintenance Section). Do not fill the crankcase above “FULL” mark (X) on the oil level gauge.

Clean the oil filler cap. Install the oil filler cap. g00622328 Illustration 35 (1) Oil level gauge (2) Oil filler cap 3. Record the amount of oil that is added. For the next oil sample and analysis, include the total amount of oil that has been added since the previous sample. This will help to provide the most accurate oil analysis.