Caterpillar — Caterpillar C11 and C13 Industrial Engines Operation and Maintenance Manual

70 SEBU7901-01 Maintenance Section Engine Crankcase Breather - Clean Observe the service indicator. The air cleaner element should be cleaned or the air cleaner element should be replaced when one of the following conditions occur: i01848984 Engine Crankcase Breather - Clean The yellow diaphragm enters the red zone. SMCS Code: 1317-070 The red piston locks in the visible position. Test the Service Indicator Service indicators are important instruments. Check for ease of resetting. The service indicator should reset in less than three pushes. Check the movement of the yellow core when the engine is accelerated to the engine rated speed.

The yellow core should latch approximately at the greatest vacuum that is attained. g00485291 Illustration 34 If the service indicator does not reset easily, or if the yellow core does not latch at the greatest vacuum, the service indicator should be replaced. If the new service indicator will not reset, the hole for the service indicator may be plugged. (1) Bolts. (2) Hose clamp. (3) Breather cover. NOTICE Perform this maintenance with the engine stopped. The service indicator may need to be replaced frequently in environments that are severely dusty, if necessary. Replace the service indicator annually regardless of the operating conditions.

Replace the service indicator when the engine is overhauled, and whenever major engine components are replaced. If the crankcase breather is not maintained on a regular basis, the crankcase breather will become plugged. A plugged crankcase breather will cause excessive crankcase pressure that may cause crankshaft seal leakage. Note: When a new service indicator is installed, excessive force may crack the top of the service indicator. Tighten the service indicator to a torque of 2 N·m (18 lb in). 1. Loosen hose clamp (2) and remove the hose from breather cover (3). 2. Loosen four bolts (1) for the breather cover and remove breather cover (3). 3.

Remove the breather element and wash the breather element in solvent that is clean and nonflammable. Allow the breather element to dry. 4. Install a breather element that is clean and dry. Install breather cover (3) and install bolts (1). Refer to the Specifications, SENR3130 in order to locate the proper torques. 5. Install the hose. Install hose clamp (2). Refer to the Specifications, SENR3130 in order to locate the proper torques.