Caterpillar — Caterpillar C11 and C13 Industrial Engines Operation and Maintenance Manual

SEBU7901-01 73 Maintenance Section Engine Oil and Filter - Change If the engine is not equipped with a drain valve, remove the oil drain plug in order to allow the oil to drain. If the engine is equipped with a shallow sump, remove the bottom oil drain plugs from both ends of the oil pan. After the oil has drained, the oil drain plugs should be cleaned and installed. Replace the Oil Filter NOTICE Caterpillar oil filters are built to Caterpillar speci- fications. Use of an oil filter not recommended by Caterpillar could result in severe engine damage to the engine bearings, crankshaft, etc., as a result of the larger waste particles from unfiltered oil entering the engine lubricating system.

Only use oil filters recommended by Caterpillar. g00103713 Illustration 37 Typical filter mounting base and filter gasket 3. Clean the sealing surface of the filter mounting base. Ensure that all of the old oil filter gasket is removed. 1. Remove the oil filter with a 1U-8760 Chain Wrench. 4. Apply clean engine oil to the new oil filter gasket. 2. Cut the oil filter open with a 175-7546 Oil Filter Cutter Gp. Break apart the pleats and inspect the oil filter for metal debris. An excessive amount of metal debris in the oil filter may indicate early wear or a pending failure. NOTICE Do not fill the oil filters with oil before installing them.

This oil would not be filtered and could be contaminat- ed. Contaminated oil can cause accelerated wear to engine components. Use a magnet to differentiate between the ferrous metals and the nonferrous metals that are found in the oil filter element. Ferrous metals may indicate wear on the steel and cast iron parts of the engine. 5. Install the oil filter. Tighten the oil filter until the oil filter gasket contacts the base. Tighten the oil filter by hand according to the instructions that are shown on the oil filter. Do not overtighten the oil filter. Nonferrous metals may indicate wear on the aluminum parts, brass parts or bronze parts of the engine.

Parts that may be affected include the following items: main bearings, rod bearings, turbocharger bearings, and cylinder heads. Fill the Engine Crankcase 1. Remove the oil filler cap. Refer to the Operation and Maintenance Manual, “Refill Capacities and Recommendations” for more information. Due to normal wear and friction, it is not uncommon to find small amounts of debris in the oil filter. Consult your Caterpillar dealer in order to arrange for a further analysis if an excessive amount of debris is found in the oil filter. NOTICE If equipped with an auxiliary oil filter system or a re- mote oil filter system, follow the OEM or filter manu- facturer’s recommendations.

Under filling or overfilling the crankcase with oil can cause engine damage. NOTICE To prevent crankshaft bearing damage, crank the en- gine with the fuel OFF. This will fill the oil filters before starting the engine. Do not crank the engine for more than 30 seconds. 2. Start the engine and run the engine at “LOW IDLE” for two minutes. Perform this procedure in order to ensure that the lubrication system has oil and that the oil filters are filled. Inspect the oil filter for oil leaks.