80 SEBU7901-01 Maintenance Section Fuel Tank Water and Sediment - Drain NOTICE Use a suitable container to catch any fuel that might spill. Clean up any spilled fuel immediately. i02436696 Fuel Tank Water and Sediment - Drain 1. Stop the engine. Turn the ignition switch to the OFF position or disconnect the battery. Refer to the Operation and Maintenance Manual, “Battery or Battery Cable - Disconnect” topic (Maintenance Section) for more information. Shut off the fuel supply valve (if equipped). SMCS Code: 1273-543-M&S NOTICE Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, test- ing, adjusting and repair of the product.
Be prepared to collect the fluid with suitable containers before open- ing any compartment or disassembling any compo- nent containing fluids. 2. It may be necessary to relieve residual fuel pressure from the fuel system before the fuel filter is removed. Wait for one to five minutes until the fuel pressure has lowered. Use a suitable container in order to catch any fuel that may spill. Refer to Special Publication, NENG2500, “Caterpillar Dealer Service Tool Catalog” for tools and supplies suitable to collect and contain fluids on Caterpillar products. 3. Remove the used fuel filter and discard the used fuel filter. Dispose of all fluids according to local regulations and mandates. 4.
Clean the gasket sealing surface of the fuel filter base. Ensure that all of the old gasket is removed. 5. Apply clean diesel fuel to the new fuel filter gasket. Fuel Tank Fuel quality is critical to the performance and to the service life of the engine. Water in the fuel can cause excessive wear to the fuel system. Condensation occurs during the heating and cooling of fuel. The condensation occurs as the fuel passes through the fuel system and the fuel returns to the fuel tank. This causes water to accumulate in fuel tanks. Draining the fuel tank regularly and obtaining fuel from reliable sources can help to eliminate water in the fuel.
NOTICE Do not fill the secondary fuel filter with fuel before in- stalling. The fuel would not be filtered and could be contaminated. Contaminated fuel will cause acceler- ated wear to fuel system parts. NOTICE In order to maximize fuel system life and prevent pre- mature wear out from abrasive particles in the fuel, a two micron high efficiency fuel filter is required for all Caterpillar Electronic Unit Injectors. Caterpillar High Efficiency Fuel Filters meet these requirements. Con- sult your Caterpillar dealer for the proper part num- bers. Drain the Water and the Sediment Fuel tanks should contain some provision for draining water and draining sediment from the bottom of the fuel tanks.
Open the drain valve on the bottom of the fuel tank in order to drain the water and the sediment. Close the drain valve. 6. Install the new fuel filter. Spin the fuel filter onto the fuel filter base until the gasket contacts the base. Use the rotation index marks on the filters as a guide for proper tightening. Tighten the filter according to the instructions that are on the fuel filter. Do not overtighten the filter. Check the fuel daily. Drain the water and sediment from the fuel tank after operating the engine or drain the water and sediment from the fuel tank after the fuel tank has been filled. Allow five to ten minutes before performing this procedure. 7. Open the fuel supply valve.
The engine will need to be purged of air. Refer to the Operation and Maintenance Manual, “Fuel System - Prime” topic (Maintenance Section) for more information. Fill the fuel tank after operating the engine in order to drive out moist air. This will help prevent condensation. Do not fill the tank to the top. The fuel expands as the fuel gets warm. The tank may overflow.