SEBU7901-01 81 Maintenance Section Hoses and Clamps - Inspect/Replace Some fuel tanks use supply pipes that allow water and sediment to settle below the end of the fuel supply pipe. Some fuel tanks use supply lines that take fuel directly from the bottom of the tank. If the engine is equipped with this system, regular maintenance of the fuel system filter is important. Check for the following conditions: End fittings that are damaged or leaking Outer covering that is chafed or cut Exposed wire that is used for reinforcement Fuel Storage Tanks Outer covering that is ballooning locally Drain the water and the sediment from the fuel storage tank during the following conditions:
Flexible part of the hose that is kinked or crushed Armoring that is embedded in the outer covering Weekly Oil change A constant torque hose clamp can be used in place of any standard hose clamp. Ensure that the constant torque hose clamp is the same size as the standard clamp. Refill of the tank This will help prevent water or sediment from being pumped from the storage tank into the engine fuel tank. A 2 micron filter for the breather vent on the fuel tank is also recommended. Refer to Special Publication, SENR9620, “Improving Fuel System Durablity”. Due to extreme temperature changes, the hose will heat set. Heat setting causes hose clamps to loosen. This can result in leaks.
A constant torque hose clamp will help to prevent loose hose clamps. Each installation application can be different. The differences depend on the following factors: If a bulk storage tank has been refilled or moved recently, allow adequate time for the sediment to settle before filling the engine fuel tank. Internal baffles in the bulk storage tank will also help trap sediment. Filtering fuel that is pumped from the storage tank helps to ensure the quality of the fuel. When possible, water separators should be used.
Type of hose Type of fitting material Anticipated expansion and contraction of the hose Anticipated expansion and contraction of the fittings i02121526 Hoses and Clamps - Inspect/Replace Replace the Hoses and the Clamps SMCS Code: 7554-040; 7554-510 Pressurized System: Hot coolant can cause seri- ous burns. To open the cooling system filler cap, stop the engine and wait until the cooling system components are cool. Loosen the cooling system pressure cap slowly in order to relieve the pres- sure. Inspect all hoses for leaks that are caused by the following conditions: Cracking Softness Loose clamps 1. Stop the engine. Allow the engine to cool. Replace hoses that are cracked or soft.
Tighten any loose clamps. 2. Loosen the cooling system filler cap slowly in order to relieve any pressure. Remove the cooling system filler cap. NOTICE Do not bend or strike high pressure lines. Do not in- stall bent or damaged lines, tubes or hoses. Repair any loose or damaged fuel and oil lines, tubes and hoses. Leaks can cause fires. Inspect all lines, tubes and hoses carefully. Tighten all connections to the rec- ommended torque. Note: Drain the coolant into a suitable, clean container. The coolant can be reused. 3. Drain the coolant from the cooling system to a level that is below the hose that is being replaced. 4. Remove the hose clamps.