Caterpillar — Caterpillar C11 and C13 Industrial Engines Operation and Maintenance Manual

82 SEBU7901-01 Maintenance Section Jacket Water Heater - Check 5. Disconnect the old hose. Oil Consumption as an Overhaul Indicator 6. Replace the old hose with a new hose. 7. Install the hose clamps with a torque wrench. Oil consumption, fuel consumption, and maintenance information can be used to estimate the total operating cost for your Caterpillar engine. Oil consumption can also be used to estimate the required capacity of a makeup oil tank that is suitable for the maintenance intervals. Note: Refer to the Specifications, SENR3130, “Torque Specifications” in order to locate the proper torques. 8. Refill the cooling system. 9. Clean the cooling system filler cap.

Inspect the cooling system filler cap’s gaskets. Replace the cooling system filler cap if the gaskets are damaged. Install the cooling system filler cap. Oil consumption is in proportion to the percentage of the rated engine load. As the percentage of the engine load is increased, the amount of oil that is consumed per hour also increases. The oil consumption rate (brake specific oil consumption) is measured in grams per kW/h (lb per bhp). The brake specific oil consumption (BSOC) depends on the engine load. Consult your Caterpillar dealer for assistance in determining the typical oil consumption rate for your engine. 10. Start the engine. Inspect the cooling system for leaks.

i02486400 Jacket Water Heater - Check When an engine’s oil consumption has risen to three times the original oil consumption rate due to normal wear, an engine overhaul should be scheduled. There may be a corresponding increase in blowby and a slight increase in fuel consumption. SMCS Code: 1383-535 Jacket water heaters help to improve startability in ambient temperatures that are below 21 °C (70 °F). All installations that require automatic starting should have jacket water heaters. Overhaul Options Check the operation of the jacket water heater. For an ambient temperature of 0 °C (32 °F), the heater should maintain the jacket water coolant temperature at approximately 32 °C (90 °F).

Before Failure Overhaul A planned overhaul before failure may be the best value for the following reasons: Costly unplanned downtime can be avoided. i01848653 Overhaul Considerations Many original parts can be reused according to the standards for reusable parts. SMCS Code: 7595-043 The engine service life can be extended without the risk of a major catastrophe due to engine failure. Reduced hours of operation at full load will result in a lower average power demand. A decreased average power demand should increase both the engine service life and the overhaul interval. The best cost/value relationship per hour of extended life can be attained.

The need for an overhaul is generally indicated by increased fuel consumption and by reduced power. After Failure Overhaul If a major engine failure occurs and the engine must be removed, many options are available. An overhaul should be performed if the engine block or the crankshaft needs to be repaired. The following factors are important when a decision is being made on the proper time for an engine overhaul: If the engine block is repairable and/or the crankshaft is repairable, the overhaul cost should be between 40 percent and 50 percent of the cost of a new engine with a similar exchange core.

The need for preventive maintenance The quality of the fuel that is being used The operating conditions This lower cost can be attributed to three aspects: The results of the S·O·S analysis Specially designed Caterpillar engine features