SEBU7901-01 83 Maintenance Section Overhaul Considerations Caterpillar dealer exchange components Unscheduled downtime Caterpillar Inc. remanufactured exchange components Costly repairs Damage to other engine parts Overhaul Recommendation Reduced engine efficiency To minimize downtime, a scheduled engine overhaul by your Caterpillar dealer is recommended. This will provide you with the best cost/value relationship. Increased fuel consumption Reduced engine efficiency and increased fuel consumption translates into higher operating costs. Therefore, Caterpillar Inc. recommends repairing out-of-spec parts or replacing out-of-spec parts. Note:
Overhaul programs vary according to the engine application and according to the dealer that performs the overhaul. Consult your Caterpillar dealer for specific information about the available overhaul programs and about overhaul services for extending the engine life. Inspection and/or Replacement Piston Rings, Crankshaft Bearings, Valve Rotators, and Crankshaft Seals If an overhaul is performed without overhaul service from your Caterpillar dealer, be aware of the following maintenance recommendations. The following components may not last until the second overhaul. Unit Fuel Injector Clean the fuel injector body and replace the O-rings.
Replace the O-rings and the gasket on the injector sleeve. Clean the area around the injector seating in the injector sleeve. Refer to the Service Manual for the complete procedure, or consult with your Caterpillar dealer for assistance. Thrust bearings Main bearings Rod bearings Valve rotators Rebuild or Exchange Crankshaft seals Caterpillar Inc. recommends the installation of new parts at each overhaul period. Cylinder Head Assembly, Connecting Rods, Pistons, Cylinder Liners, Turbocharger, Cylinder Packs, Oil Pump, and Fuel Transfer Pump Inspect these parts while the engine is disassembled for an overhaul.
These components should be inspected according to the instructions that are found in various Caterpillar reusability publications. The Special Publication, SEBF8029 lists the reusability publications that are needed for inspecting the engine parts. Inspect the crankshaft for any of the following conditions: Deflection If the parts comply with the established inspection specifications that are expressed in the reusable parts guideline, the parts should be reused. Damage to the journals Bearing material that has seized to the journals Parts that are not within the established inspection specifications should be dealt with in one of the following manners:
Check the journal taper and the profile of the crankshaft journals. Check these components by interpreting the wear patterns on the following components: Salvaging Rod bearing Repairing Main bearings Replacing Note: If the crankshaft is removed for any reason, use the magnetic particle inspection process to check for cracks in the crankshaft. Parts that do not comply with the established inspection specifications can result in the following problems: