Caterpillar — Caterpillar C11 and C13 Industrial Engines Operation and Maintenance Manual

86 SEBU7901-01 Maintenance Section Starting Motor - Inspect Environmental Factors i01539769 Turbocharger - Inspect Ambient temperatures The engine may be exposed to extended operation in extremely cold environments or hot environments. Valve components can be damaged by carbon buildup if the engine is frequently started and stopped in very cold temperatures. Extremely hot inlet air reduces engine performance. SMCS Code: 1052-040; 1052 Periodic inspection and cleaning is recommended for the turbocharger compressor housing (inlet side). Any fumes from the crankcase are filtered through the air inlet system.

Therefore, by-products from oil and from combustion can collect in the turbocharger compressor housing. Over time, this buildup can contribute to loss of engine power, increased black smoke and overall loss of engine efficiency. Air Quality The engine may be exposed to extended operation in an environment that is dirty or dusty, unless the equipment is cleaned regularly. Mud, dirt and dust can encase components. Maintenance can be very difficult. The buildup can contain corrosive chemicals. If the turbocharger fails during engine operation, damage to the turbocharger compressor wheel and/or to the engine may occur.

Damage to the turbocharger compressor wheel can cause additional damage to the pistons, the valves, and the cylinder head. Buildup Compounds, elements, corrosive chemicals and salt can damage some components. Altitude Problems can arise when the engine is operated at altitudes that are higher than the intended settings for that application. Necessary adjustments should be made. NOTICE Turbocharger bearing failures can cause large quan- tities of oil to enter the air inlet and exhaust systems. Loss of engine lubricant can result in serious engine damage.

Improper Operating Procedures Extended operation at low idle Minor leakage of a turbocharger housing under ex- tended low idle operation should not cause problems as long as a turbocharger bearing failure has not oc- curred. Frequent hot shutdowns Operating at excessive loads Operating at excessive speeds When a turbocharger bearing failure is accompanied by a significant engine performance loss (exhaust smoke or engine rpm up at no load), do not continue engine operation until the turbocharger is repaired or replaced.

Operating outside the intended application Improper Maintenance Procedures Extending the maintenance intervals An inspection of the turbocharger can minimize unscheduled downtime. An inspection of the turbocharger can also reduce the chance for potential damage to other engine parts. Failure to use recommended fuel, lubricants and coolant/antifreeze Note: Turbocharger components require precision clearances. The turbocharger cartridge must be balanced due to high rpm. Severe Service Applications can accelerate component wear. Severe Service Applications require more frequent inspections of the cartridge. i00651416 Starting Motor - Inspect SMCS Code: 1451-040; 1453-040 Caterpillar Inc.

recommends a scheduled inspection of the starting motor. If the starting motor fails, the engine may not start in an emergency situation. Removal and Installation Check the starting motor for proper operation. Check the electrical connections and clean the electrical connections. Refer to the Service Manual for more information on the checking procedure and for specifications or consult your Caterpillar dealer for assistance. For options regarding the removal, installation, repair and replacement, consult your Caterpillar dealer. Refer to the Service Manual for this engine for the procedure and specifications.