SEBU7901-01 85 Maintenance Section Radiator - Clean Inspect the fins for damage. Bent fins may be opened with a “comb”. Inspect these items for good condition: welds, mounting brackets, air lines, connections, clamps, and seals. Make repairs, if necessary. Do not operate the engine with the Instruction Plate cover removed from the clutch. Personal injury may result. If the clutch is damaged to the point of burst fail- ure, expelled pieces can cause personal injury to anyone in the immediate area. Proper safeguards must be followed to help prevent accidents. For more detailed information on cleaning and inspection, refer to Special Publication, SEBD0518, “Know Your Cooling System”.
i00151038 Severe Service Application - Check i01604510 Radiator - Clean SMCS Code: 1000-535 SMCS Code: 1353-070 Severe service is an application of an engine that exceeds current published standards for that engine. Caterpillar maintains standards for the following engine parameters: Note: Adjust the frequency of cleaning according to the effects of the operating environment. Inspect the radiator for these items: damaged fins, corrosion, dirt, grease, insects, leaves, oil, and other debris. Clean the radiator, if necessary. Performance (power range, speed range, and fuel consumption) Fuel quality Personal injury can result from air pressure.
Altitude range Personal injury can result without following prop- er procedure. When using pressure air, wear a pro- tective face shield and protective clothing. Maintenance intervals Oil selection and maintenance Coolant selection and maintenance Maximum air pressure at the nozzle must be less than 205 kPa (30 psi) for cleaning purposes. Environmental qualities Installation Pressurized air is the preferred method for removing loose debris. Direct the air in the opposite direction of the fan’s air flow. Hold the nozzle approximately 6 mm (0.25 inch) away from the fins. Slowly move the air nozzle in a direction that is parallel with the tubes.
This will remove debris that is between the tubes. Refer to the standards for the engine or consult with your Caterpillar dealer in order to determine if the engine is operating within the defined parameters. Severe service operation can accelerate component wear. Engines that operate under severe conditions may need more frequent maintenance intervals in order to ensure maximum reliability and retention of full service life. Pressurized water may also be used for cleaning. The maximum water pressure for cleaning purposes must be less than 275 kPa (40 psi). Use pressurized water in order to soften mud. Clean the core from both sides.
Due to individual applications, it is not possible to identify all of the factors which can contribute to severe service operation. Consult your Caterpillar dealer for the unique maintenance that is necessary for the engine. Use a degreaser and steam for removal of oil and grease. Clean both sides of the core. Wash the core with detergent and hot water. Thoroughly rinse the core with clean water. After cleaning, start the engine and accelerate the engine to high idle rpm. This will help in the removal of debris and drying of the core. Stop the engine. Use a light bulb behind the core in order to inspect the core for cleanliness. Repeat the cleaning, if necessary.
The operating environment, improper operating procedures and improper maintenance procedures can be factors which contribute to severe service conditions.