Lithium-Ion Battery Applications 187 Now here you may notice that I am combining two categories into the same discussion. In this instance, I am consolidating both traditional PHEVs with their closely related cousin, the EREV. In these cases, the main difference is whether the system is a parallel design or a series design. Both of these configurations were discussed in detail in Chapter 3, however, it is worth a brief review at this point.
In the parallel hybrid configuration, the electric motors are traditionally sandwiched into the drivetrain putting the electric motors in the direct driveline, whereas in the series configura- tion the ICE is not actually connected directly to the transmission and will operate like a generator providing power to the electric motors. The EREV essentially is always in EV mode, but with an on-board generator to provide continuous power to the wheels. So now let us take a look at a couple of examples of these technologies in their applications. First, we will start with the Toyota Prius Plug-In Hybrid.
The Prius PHEV uses a 4.4-kWh lithium-ion battery supplied by the Prime Earth Electric Vehicle (PEVE) company, which is a joint venture between Toyota and Panasonic (Green Car Congress, 2009). This battery offers the driver between 10 and 15 miles of electric drive range depending on factors such as the tem- perature, driving style, and other factors. With a relatively small battery, it can also charge very quickly, using a 240-V charger the battery can fully charge in only 90 min and with a standard 120-V charger in only 3 h. The battery weighs only about 180 pounds and mounts under the rear cargo floor area of the hatchback.
According to the Environmental Protection Agency (EPA) ratings, the Prius PHEV achieves about 95 MPGe and uses about 29 kWh per 100 miles. In the United States, Ford Motor Company has also taken up the PHEV race offering several different vehicles with the same PHEV battery technology. First is the Ford C-Max Energi PHEV followed by the Ford Fusion Energi PHEV and the Escape PHEV that was originally being planned for a 2012 introduction but has not yet hit the showroom. One aspect of the Ford battery strategy that has been seen in multiple conference proceedings and in personal conversations with the team is the drive to use identical batteries for all of these applications.
Even talking about common designs is not sufficient to meet the directive. In order to achieve significant cost reductions, Ford’s focus (pun intended) is to use the same battery across as many applications as possible. This will generate higher volumes and should therefore help to drive down the cost of the batteries faster. Both the Ford C-Max Energi and the Ford Fusion Energi PHEVs use a 7.6-kWh battery pack that is supplied by Panasonic. This offers a pure electric drive range of about 20 miles and an EPA estimated 88 MPGe using about 37 kWh per 100 miles. In the C-Max, the battery mounts under the rear cargo floor.
The battery is air cooled, pulling fresh air in through an integrated fan and exhausting out the top of the battery pack in two locations. The biggest challenge with Ford’s requirement to use identical batteries is that the battery packaging is not specific for each vehicle therefore the packaging does not necessarily fit nicely into all of its applications ( Figure 10 ).