188 Chapter 15 Figure 10 Ford C-Max lithium-ion battery pack. Courtesy Ford Motor Company. General Motor’s Chevrolet Volt is an example of the sister technology to the PHEV, the EREV. Combining a 16.5-kWh lithium-ion battery pack using LG Chem pouch-type cells with a small internal combustion engine, the Volt offers the driver a range of about 38 electric miles and achieves an EPA rating of about 98 MPGe using about 35 kWh per 100 miles. The Volt’s battery pack is mounted underneath the vehicle filling the former transmission tunnel and fuel tank areas in a “T”-shaped pack.
GM went with a liquid-cooled solution to help ensure both rapid cooling and in colder temperatures faster heating of the batteries. The Volt pack, branded “Voltec” by GM uses a total of 288 lithium-ion pouch-type cells assembled into four modules. Each cell is separated by a plastic frame on one side and an aluminum cooling fin on the other side. The cells are electrically connected on the top of the module using a plastic interconnect board with the series/parallel connectors integrated into that board. The Voltec pack also includes a service disconnect in the middle of the pack that is accessible from the passenger compartment.
To help manage the pack’s temperatures, a heat shielding insulation covers the top plastic cover ( Figure 11 ). Battery Electric Vehicles Perhaps the most well-known fully EV on the market today is made by Tesla. Their first introduction was the Roadster and their second vehicle is the Model-S sedan. The fully EV differs from the hybrids in that 100% of the power and propulsion are provided by an electric battery, there is no ICE to back up the vehicle in these applications. In developing their battery solution, Tesla went a very different route than the “big” OEMs. Rather than creating a new battery format that fits in the into the vehicle architecture, they