BAIC — Grid and Stationary Applications

204 Chapter 15 Figure 25 A123 Grid Storage System™ expenses associated with putting in new power plants. Many utilities are experimenting with installing energy storage in their distributed networks and strategically located near the areas of greatest demand. When compared to the massive capital costs of putting a new coal-fired power plant in place many utilities are finding that it is much more cost-effective to install smaller energy storage systems strategically within their networks in order to either delay or offset the capital expenses that would otherwise have been generated by installing new power plants.

Ancillary Services One of the most important ancillary services that are offered is frequency regulation. Fre- quency regulation involves managing the variation in generation and ensuring that the output meets the legally required frequency range. In the United States, the legally mandated fre- quency that energy must be distributed at is 60 Hz and in Europe it is 50 Hz. If the power that is being distributed falls too far outside of an acceptable range, often as low as 0.5 Hz from the mean, many utilities will automatically begin to disconnect in order to avoid damaging the equipment.

Therefore, energy storage can be used in order to ensure that these “spikes” in frequency are regulated and that the power being transmitted is always at the specified frequency. Consider the battery a buffer in this instance being used to reduce the differences in demand and load and maintain a constant frequency. Another ancillary service that may use energy storage is in support of spinning reserves and nonspinning reserves and is referred to as a supplemental reserve. In the United States, there are regulations that require utility companies have power generation capacity available that is in excess of current usage and can respond within 10 min.

If this capacity is required to be online but not being used, it is referred to as “spinning reserves,” this is in essence a power generation that is up and running and can respond quickly to any potential outages. In addition to this, there is a requirement for “nonspinning” reserves of power. This has the same requirement that it can be spun up and be online within 10 min. Finally, backup reserves are a backup power that is stored