Lithium-Ion Battery Applications 205 and that can be brought online after all of the other reserves are up and running. In essence, this system is designed in order to ensure that even during the peak usages, such as during the hottest days of the year, there is enough power to meet all demands. In this application, batteries are also beginning to be introduced in order to provide some of the supplemental reserves. Another ancillary service is voltage support. This function operates in much the same way that frequency regulations services operate. Voltage support provides a regulation of the voltage of the system during times of peak demand and usage.
Finally, black start is an ancillary service whereby energy storage is used as a backup to provide energy and power to the grid during catastrophic type failures of the grid system. In this case, the stored energy is used to power the grid until the main generators can be brought back online. Transmission and Distribution Infrastructure Services Transmission and distribution (T&D) upgrade deferral is the act of installing smaller energy storage systems throughout the utilities service area instead of installing new capacity genera- tion equipment in order to meet peak demands.
As was discussed earlier, most utilities are required by legal mandate to have installed capacity to meet the peak usages of the grid, even though those peaks may only occur as little as a couple of days per year. In this case, energy storage can be installed in strategically located areas in order to meet the demand on those days instead of installing expensive new main power generation equipment. Another aspect of T&D deferrals and services is the use of energy storage in order to relieve the congestion in the system. This occurs when transmission sources are not adequate to support the peak demands on the system.
In these instances, the utilities may actually incur additional transmission charges due to the congestion in the system as well as having to use higher cost energy sources during these periods. Again, strategically located energy storage systems can be used in order to relieve the stress on the T&D systems and to ensure continu- ous supply to the customers. Customer Energy Management Services Energy storage can also be used to improve the customer’s power experiences. For instance, energy storage can be used to reduce the variations in the power and voltage, reduce the variations in the frequency, and to reduce the impact of interruptions in service to the end customer.
Reliability can be ensured through the installation of energy storage as well. This essentially provides “islanding” support to the customer to ensure that there is no loss of service during catastrophic events. Another customer service is being able to “time-shift” the energy usage. Many utilities are offering “time-of-use” billing, where the customer is charged a different rate depending on the time of day. For example, higher rates would be charged during peak times and lower