Lithium-Ion Battery Applications 207 acid battery manufacturer Enersys acquired both Quallion and ABSL in order to focus on the military and aerospace market for primary and secondary lithium-ion batteries. The National Aeronautics Space Administration (NASA) has also been working in concert with several battery manufacturers to develop battery systems that can survive the challenging uses of space-based applications, from advanced robotics and space station power to lunar and Martian rovers. Until the early 2000s, the main types of batteries used in satellite and space-based applica- tions were either NiCd through the 1980s and then NiMh through the 1990s.
It was not until the early 2000s when lithium-ion began being introduced into space-based applications. Today, more than 98% of all batteries used in government, private, and commercial space applications are lithium-ion based (Borthomieu, 2014). The biggest reason for the switch to lithium-ion batteries in the aerospace world is pretty clear—higher energy density. In these applications, managing the weight of the final product is vital, so by integrating lithium-ion batteries, engineers were able to increase the amount of energy on board while still reducing the weight. In satellite applications, there is a direct relationship between weight and cost.
So the lighter the unit, the lower the cost to put it into orbit. There are typically three different types of satellite applications and each one has a different battery requirement. First are the low earth orbit satellites. This requires about a 60-minute discharge cycle with a 30-minute charge period that is repeated multiple times per day as the satellite circles the earth. But they also have a lifetime requirement of up to 15 years.
Due to the relatively short 90-minute cycle, they will go through about 5500 cycles per year but as they use a low depth of discharge, usually from 10% to 40% State of Charge (SOC) swing, they are only “partial” cycles which enables lithium-ion to operate successfully in these applications (Borthomieu, 2014). The second satellite application is the geostationary earth orbit satellites. These satellites stay in one spot relative to a fixed position on the earth and so have a 24-hour cycle, therefore both the discharge rate and the charge rates are very low except for the period when the satellite is eclipsed from the sun which is about a 72 min period of time.
With these long charge/dis- charge cycles, the battery only needs between 1500 and 2000 cycles over the 15- to 20-year life of the satellite (Borthomieu, 2014). The third and final satellite application for batteries is the high earth orbit and medium earth orbit satellites. Batteries in these applications will require about the same performance requirements as those in the GEO category but will require lifetimes up to about 2500 cycles for up to 15 years of operation or so (Borthomieu, 2014). There are a couple of things that make satellite batteries unique. First is the need to meet very tough shock and vibration requirements.
As these applications will have to be launched via a rocket into space, they must be able to survive this very challenging shock and vibration profile. In addition to this, there is a need to ensure that the batteries are resistant to solar radiation which can negatively impact electronics and material performance. Finally, these