daewoo — Daewoo D1146 D1146TI DE08TIS Diesel Engine Maintenance Manual

D1146/D1146TI/DE08TIS MAINTENANCE MANUAL In addition, a strainer is fitted into joint bolt on the inlet side of the fuel feed pump to filtrate any foreign substances possibly mixed in fuel. M1232 2) disassembly Strainer (50 mesh) Strainer bolt ass`y : 30, 31 M1232 z Clamp the feed pump with a vise and disassemble the hollow screw (30, 32), strainer (31) and seal ring (35, 36). z Take off the priming pump (25), plug (16), both seal rings (18), spring (15), and check valve (14). z Take off the plug (7), seal ring (8), spring (6), and piston (5) on the piston side. z Pull out the snap ring (20) holding the tappet (10). z Disassemble the snap ring, then take off the tappet (10) and push rod (1).

3) Inspection z If the check valve is damaged or scored on its seat face, replace it with a new z Inspect the piston and tappet for damage. one. z Replace the push rod if excessively worn, and replace together with the pump housing if required. The inspection for wear should be performed in the same procedure as for suction pressure test described below. 116 Printed in Jan. 2001 PS-MMA0415-E1A