D1146/D1146TI/DE08TIS MAINTENANCE MANUAL z Maintenance specification table 136 Printed in Jan. 2001 PS-MMA0415-E1A Group Part Inspection Item Stand value for assembly Limit for use Correction Remark Engine body Cylinder block & liner Inside diameter of cylinder liner for wear φ111~φ111.022 φ111.122 Replace liner Measure unworn portion beneath the rim of the upper side Amount of liner projection 0.03~0.08 - Need amount of projection without fail Projection difference between adjacent liners : 0.15 ↓ The flatness of upper surface of cylinder block 0.05 - Correct with a surface grinder Referenced length :
200mm Hydraulic test for 1 minute (kg/cm2) 4 - Replace if leaky Cylinder head & valve Valve seat depression Intake 0~0.3 0.55 Replace valve seat Exhaust 0~0.3 0.55 Cylinder head height 109.9 ~110.1 108.4 Replace cyl. head Hydraulic test for 1 minute (kg/cm2) 4 - Replace if leaky Water temp. 70°C Major moving parts Piston Outer dia.
of piston φ110.801~φ110.959 Replace liner Measure at 13mm away from lower surface of piston Clearance between piston and liner 0.041~0.221 0.3 Replace one worn more Width of piston ring grooves Top ring - - Replace piston if groove width is beyond specified value 2nd ring 3.06~3.08 - Oil ring 4.04~4.06 - Piston projection from cylinder block upper surface 0~0.12 Must exist Measure unworn portion beneath the rim of the upper side Permissible weight difference of each piston ±15 g 96 g↓ Replace piston Piston ring Piston ring gap Top ring 0.40~0.60 1.5 Replace ring Standard gauge inside diameter :
φ108 2nd ring 0.40~0.60 1.5 Oil ring 0.30~0.50 1.5 Piston ring side clearance Top ring - - Replace ring or piston Limit for use is if for standard clearance 2nd ring 0.07~0.102 0.15 Oil ring 0.05~0.085 0.15 Direction of ring gap - - Cross Install by 120° Piston pin Outer diameter of piston pin φ41.994 ~ φ42 φ41.94 Replace piston pin Clearance between piston pin and its bush 0.003~0.015 0.08 Replace one worn more