daewoo — Daewoo D1146 D1146TI DE08TIS Diesel Engine Maintenance Manual

D1146/D1146TI/DE08TIS MAINTENANCE MANUAL 137 Printed in Jan.

2001 PS-MMA0415-E1A Group Part Inspection Item Stand value for assembly Limit for use Correction Remark Major moving parts Crank shaft Radial run-out of journal and pin - 0.01 Correct with a grinder Measure In horizontal and vertical directions (against axial direction) Outside diameter of journal φ83.966~φ83.988 φ83 Use under sized bearings respectively (0.25, 0.5, 0.75, 1.0) Outside diameter of pin φ70.971~φ70.990 φ70 Ellipticity of journal and pin 0.008 0.025 Concentricity of journal and pin 0.01 0.03 Taper of journal and pin 0.02 0.03 Clearance between crankshaft and bearing 0.052~0.122 0.25 Replace bearings Measure at crown part not parting line End play of crankshaft 0.15~0.325 0.5 Replace thrust bearing Run-out of crankshaft 0.06 0.1 ↓ Adjust by a press if bended Measure at No.4 bearing (No.

1 & 7 bearing supported) Balance of crankshaft (g.cm) 60 ↓ 60 or less Check dynamic balance Measure at 400 rpm Torque value journal bearing cap bolt (kg.m) 30 - Coat the bolt with engine oil Clean out foreign objects on joining surface Crush height of journal bearing 0.08~0.110 - Measure after tightening metal cap and releasing one stud Oil seal for wear(crank shaft rear) - - Replace oil seal if oil leaking Connecting rod End play of con-rod 0.170 ~ 0.248 0.50 Replace con-rod Clearance between con- rod bearing and crank pin 0.034 ~ 0.098 0.25 Replace bearing Clearance between small end bush & piston pin 0.050~0.081 0.12 Crush height of con-rod bearing 0.04~0.07 - Measure after installing the bearing and releasing one bolt Side clearance of big- end and small-end - 0.50 Replace con-rod Allowable weight difference per con-rods 30 g ↓ - Torque value of con-rod bearing cap bolt (kg.m) 18 - Coat the bolt with engine oil Clean out foreign objects on joining surface Cam shaft Diameter of cam shaft journal φ57.86~φ57.88 φ57.52 Clearance between cam shaft and cam bush 0.12~0.17 0.24 Replace cam bush End play of camshaft 0.28~0.43 0.6 Replace thrust washer Run-out of camshaft 0.05 0.2 Correct or replace the cam shaft Timing gear Clearance between idle shaft bush and idle shaft 0.025~0.091 0.15 End play of idle gear shaft 0.043~0.167 0.3 Replace thrust collar Back-lash between gears(cam, idle, crank and injection pump) 0.16~0.28 0.35 Correct or replace gear